Viewing all customer Discussions for:

36-004-10 10" Stainless Steel 2 Bar Hinge Set

Could you tell me which part i should order? Pictures were taken on the right hand side window, but I need the part for the left hand side window.

Need to replace

The window will fully open but will not close the last approximately 1 inch. The handle rotates attempting to fully close but doesn't work. I also don't see how the operator is removed. This is a Pozzi casement window.

As seen in photo "1 window corroded hinge ...", we need new 10" bottom hinges on four old Viking windows (we'll be moving the guilty sprinklers, but stainless steel replacements seem like a good idea). We also need an operator for a right-hand window (opposite opening of the one in the photo). The t ... (cont.)

The 6 inch flat bracket looks like 39-508 but is 6 inches in length . The stud rides on a black worn slide. In addition the 10 inch flat connector attaches to a stud midway on the bracket. I need the bracket and the black glider that moves across the inside of the window that is controlled by the ne ... (cont.)

Bottom hinge of a casement window. The other hardware, crank and latch are labeled truth hardware. The hinge measures 10-3/4 ". I have part #36-004-10, but it is not the same.

Need hinges for window

Hi, I attached two photos of a bracket that needs to be replaced due to worn/corrosion. I am not sure what you call it. This bracket holds up the casement window when you open it. The photo shows a closeup of the window when its open and it is not sitting on the bracket. The window is hanging o ... (cont.)

Hello, I am looking to replace this black sliding part shown in the photo. The one in the photo has a center tab, the one that is broken is missing that tab. It looks like they are all the same, left right top and bottom. Thank you

I believe the operator is the dyad sill mount and have found this on your site but am still looking for the hinge. The fixed base of the hinge that mounts on the sill is about 13". The non sliding arm is about 7 3/4". I need both LH and RH. Thank you for any assistance.

Hi, I need 3 RH and 3 LH casement window operators for Atrium windows that were manufactured in 2007

The part is on an American Standard casement window that was installed 2004

From the outside the widow hinge is on the left side. From the inside the hinge is on the right side.

Pivot shoe maybe

Need all hardware top and bottom. Do you have a complete schematic/drawing

This was the piece that was connected to the window that slid along the track. One end seems to have broken off the window, trying to find what part this is

Good Afternoon! I'm just looking to see if you all can indentify, or if you have that black piece that is being pointed to in this picture. Thank you!

The operators look ok and function well but need lubrication? The sash tracks and lower window inserts are rusted thru. the operator arms are 20810 of which I need 2 pair of left and right. And 3084of which I need 1pair of sash tracks and window inserts. Originally Marvin windows Truth Entry Guard. ... (cont.)