Viewing all customer Discussions for:

39-253RB Encore Dual Arm Operator, Sill Mount

lever say 41012 and 31876 on the back

Need to replace

It says truth on the arm.

Hi there, can you help me figure out what part I need? This is a Milgard window. I believe the part we need is called an "operator". It is completely rusted/frozen/locked up in place. We may have stripped the crank, it turns freely but does nothing. I am an unskilled homeowner, but am planning to hi ... (cont.)

Hurd brand on the crank and 14DN99P imprinted on the interior part. Dimensions are 4 7/8 inch on the short bar and 5 inches on the crank measurement

Truth hardware 41011 on straight arm 31876 on pivot arm hardware off 2000 model thermo tech casement. Looking for 6 LH and 4 Rh operating

I need a window crank mechanism and new interior folding crank handle assembly in white. The only visible part number on the locking bar is: 6699P

Hurd casement windows 2000 vintage. Need both right and left operators.

Hurd casement window mechanism doesn't close window all the way and acts like gears are stripped.

It looks like Roto Dual 39 341 and 39 342 will fit my windows. There is also a 7 inch hinge on top and bottom of windows. Can you give the part numbers for these hinges? Thank you Rich

Hi Swisco, The picture is of the right casement window next to the left casement window I'm trying to find an operator for.

I am looking to replace the dual pivot arm operator only. I need one in the orientation shown in the pictures and two in the opposite hand.

The photos show the casement window (Left hand side, Milgard 19-22" wide / 59" high). The crank device needs to be replaced. The attachment on the assembly that slides along the bottom of the window has worn out, and it pops down out of the track now, and no longer pulls the window closed. ... (cont.)

I am a contractor repairing several vinyl casement windows for a customer. At least three of the operators are no longer pulling the sash completely closed. When the crank is turned, the internal gears appear to slip or fail to catch properly under load.The operator arms are marked “TRUTH.R ... (cont.)

Milgard casement window operator stamped with the following numbers 31876 41011

good evening,I have replaced my Operators and I have one window that stops and if I force it a little the window closes. I cannot find what is the hang up. any suggestions?thank you,Meagan

We opened casement window and it would not close properly. Mechanism arms have rusted and detached from sash. Need to replace parts. The photos are of the functional casement window as we couldn't get pictures of broken one...too busy trying to keep window sash from falling off the roof. Help pleas ... (cont.)