Viewing all customer Discussions for:

39-448 Tie Bar Guide

The part shown is a twin of the broken part to be replaced. It is is installed on the sash of a US Window Factory casement w/ grid [34" x 36"]. The window is old (2003)but still operates well. It is able to crank out and in but cannot lock anymore.If you have a replacement part this will be greatly ... (cont.)

From the images sent, I'm looking for the vertical metal rod, or shaft and some of the plastic guides

This is the broken tie bar guide from my window. Which one of your tie bar guides do you recommend for a replacement?

Hi. I have an 18 year old Rivco dual crank-out window. One of the arm guides broke. See attached. I am looking for a replacement. Thanks Jerry

One of the plastic rail holders for the locking mechanism is broke and the rail is missing a locking pawl. The brand on this is Truth. Do you have this part?

Do you have a replacement for this item? Or will one of your items work for this?

Looking for a WeatherShield casement window multipoint lock tie bar guide. See photos (this piece as shown is missing the part that guides and retains the tie bar). These were installed when I built my house in 2002.Any help will be appreciated. Garry

Guide says ACME 2020. Need around 20.

This plastic piece with screws is holding the glider for the bathroom window. Can't locate replacement. Thank you

Need 1 window crank Need 1 window lock/ latch Need 1 rail & plastic slide

Looking to replace this part. Sent a photo of the broken piece and the piece just like it that isn't broken.

There are two plastic pieces holding the arm that moves up and down to lock the window. The plastic has snapped in two so I need to replace those small pieces. The pictures of the whole pieces are from a different window that is not broken. I also included picture of the arm. Thanks for your hel ... (cont.)

One of these cracked at the top, three on each side..moved middle to top just to make sure window closed fully

I believe this is from a Crestline window. The plastic part holds the metal bar that slides up and down to lock the window. What is the part called? Do you have them? How much do they cost?

Hello- Hoping that you can assist me. Our home has Atrium casement windows installed and a part broke on the locking mechanism. Tried contacting Atrium but have had no success. Found you on the internet and looked through your catalogue and had no success in identifying the part that needs to be re ... (cont.)

Casement window has a vertical tie bar part of locking function. At this height it has 3 keepers to have the tie bar continue to function. All are plastic, and wear out over time, particularly bottom one which is most stressed.

This part holds the locking rail straight in the window

Part to hold rail

These little plastic parts hold the rod that latches my casement windows . There were three on each window. The rod they hold is a hair less than 1/2 inch wide and it is flat, not round.

I need new 46.9" left hand tie bar with three roller (window has three keepers), and 3 tie bar guides like ones in pictures. It goes with a 24 series (38-091) multi point sash lock. I need a this sash lock also.