Viewing all customer Discussions for:

39-448 Tie Bar Guide

The windows remain latched at the top even though the release is up. Turns out the mechanism has come off track due to the plastic clips breaking. We need replacement plastic clips.

Looking for the part that is pink. Let me know if you have that part.

Hi, Looking for a replacement tie bar guide as pictured or a substitute. Screw holes are 1?" apart at the centers. Don't know the window manufacturer, sorry. Thanks, Sid

I have an older crank out casement window. There are two crank outs and a stationary window in the middle. One of the two crank outs has 3 broken plastic clips which hold the " slide bar" in place and allow for sliding of the locking bar to lock and unlock the window. The picture below shows the cli ... (cont.)

The bar guide for a crank out window. I found this one on your website, but the left hand side is slightly different than my original, so I want to make sure it will still work.

This is a part on our Bonneville Vinyl rolling window. It is attached to a metal arm extension that seals and locks the rolling window.

We are needed to order comparable parts that will work in place of these. We do need right & left hand operators. We are trying to order some additional parts to keep on hand for future repairs. Contact Marlin to discuss.

The plastic rail guide broke. There are two guides for each crank window. They are plastic and are attached by 2 screws

I am trying to locate a guide for the locking bar from a simonton casement windows are approximately 18 yrs old.thanks Andy

I need help in maintaining my casement window. It makes a lot of cracking noise when opening and closing. I don't see any adjusting screws. I also need to replace some of the locking guilds that are broken. I need help with the part number, please?

Please advise, I need the bracket that holds the rod that allows me to lock the window. The plastic lip broke and the rod is not able to stay locked in place to lock the window Marie

Hello, I am trying to locate this part. Any help would be greatly appreciated.

Looking for a tie bar guide for a casement window. Needs to fit between two rollers on the tie bar. I don't think the rollers are removable? Not sure. Thanks!!

its 37 11/16 long and the re is 2 hardware attached to the window that catches to hardware on tje side to lock

Need replacement plastic brace. Can you identify and provide replacement. Also how much is the cost of replacement?

Looking for this plastic part as a couple are broken the window.

I have a pair of casement windows. These are photos of the one that is in working condition. I believe only the 3 keepers need replacement on the other one. I didn't remove the hardware for fear of compounding my problem. The only marking I see anywhere is "Truth". Presumably that's the brand. Th ... (cont.)

I need the following parts 8 knobs 6 51" flat locking mechanism rods/bars 10. Inside mount locking bar clips 1 handle 10 knob locking pins

The old broken part on the left is 5/16 " and the replacement part from Harvey on the right is 7/16". Window won't close when replacement part is installed . Need a thinner guide same size as original.

Guide for window lock slide