Viewing all customer Discussions for:

32-061 21-5/8" Self-Closing Drawer Slide Pair

Hello, Im in need of a drawer slide socket. I took picture of it with Google & it shows as a 32-002 socket. Would you have any of these? I also attached a picture. I appreciate your reply.

Track wheel is dragging and has flat edge. Need replacement part for it.

Drawer track support plate

Looking for replacement drawer hardware in the sides. The rolling ball has broken off.

This part came of one of my kitchen cabinets its my by Tenn Tex Plastics part C100. They only sell in bulk and commercially so I was unable to purchase from them

Hello: Can you tell me please what to order to replace the Unigrass 6600 drawer slides shown in the attached pictures? They are approximately 22 3/8 inches long. Thank you. Rich

Our home is built by Dr. Horton with Bellview floor plan. The drawer slide bent and need replacement. I bought 22 inch everbuilt bottom mount slide set from Home Depot but the slider that gets fixed inside the cabinets is short

Hi, these seem very unique. The back end screws into the back of the cabinet. They measure 21 1/2 inches. Can you identify?

The drawer/shelf keeps coming off the glide because the glide is shifting out of position in the rear socket. Is there a fix for this?

Can you identify this drawer track back plate? I purchased item 32-089 which is very similar, but it's larger. I've included a side by side photo with 32-089. 32-089 is the larger one in the photo. The smaller one has a height of 2", width of 1 1/4" and length of 3 3/4". The inside of the channe ... (cont.)

Wellborn cabinets from 20ish years ago. Just need the plastic bracket that the rail is held in place by.

A plastic piece that holds the side track of my cabinet door broke. The plastic piece has the marking RSI. It fits onto a fork like piece at the end of the drawer slide, which is marked POW2 R20207 – RCAB. The piece that broke Had two posts on the back that inserted into two holes in the back ... (cont.)

The slide end that mounts to the cabinet front broke off. I included a photo (4413) of it installed. The other photos are of the broken part. It is a rear cabinet dowel mount with the plastic clip. I can't seem to find a replacement for this. It is about 21 inch slide and the drawer is a bottom moun ... (cont.)

I need to know what this is called and where I can purchase a replacement

Im looking for these Drawer parts Rights and Lefts

These nylon/plastic drawer slide hangers connect the metal drawer slides to the back of the cabinet through holes where the two plugs fit into

Photos on some other brackets that I need for my kitchen cabinets

Can not find this anchor for back of cabinet

The front of the one rail snap in the cabinet at the front. I am trying to replace the rails for this drawer. it's about 22" long. If I can't what can I replace it with and how do I remove the plastic thing on the cabinet without damaging the cabinet it'self. Is there an embosed part number i ... (cont.)

I have unigrass 6600 side rails . I need a back mount for the slide . I've attached pictures