Viewing all customer Discussions for:

32-061 21-5/8" Self-Closing Drawer Slide Pair

These rollers have 1/2" plastic wheels with ball bearings and have Grant DL and DR stamped on them. If you have these or an equivalent what is the minimum order for both the right and left sides? Thank you.

Can you tell by these photos which slides I need

I'm looking for a replacement part for what I believe are Rutledge cabinets. This the rear mount for the back of the cabinet. The picture is of the left side railed mounted. The right side is what I'm looking for. The only identification I can find in on the drawer itself.

Having trouble finding replacement part for this late 90's builder grade kitchen drawer. Bent slightly from wear.

I am looking for plastic rear mounts for a sliding cabinet drawer. These have plastic knobs to fit into existing drilled holes. I attached photos of the broken mounts as well as the drawer slides that need to fit in them.

The mounting bracket that attaches to the rear of a cabinet for the left sliding drawer rail.

I don't seem to be able to find a similar slide at the box stores. 1995 hardward

How to ensure i buy right size which one do i measure the one which is screwed to drawer or to the wood wall

I purchased item # 32-061 but I did not relize that the slides are connected to the back of the drawer like in the attached pictures. I cannot find the correct set to purchase and I cannot figure out how to disconnect the ones in my home. Any help is greatly appreciated!

part #. nuigrass6600. can't find ?‍?

Hi, So, I found the L-shaped bracket called V-Notch Bracket, but I need to know where to get the white L-shaped European-style drawer slider. One of the wheels is racked, and I must replace the slider. Thanks, Lex

I have a Unigrass 6600 drawer slide that I need to replace. It is. 21 5/8" long. I am having a hard time finding where to purchase one. Any information is appreciated!

The left rear bracket that holds the drawer side rail broke. What is the replacement part? Photo 4188 is the broken bracket (part of it cracked off), photo 4187 is the intack assembly for the right side, photo 4203 is the front end of the side rail, photo 4204 is the back end of the side rail that ... (cont.)

I am in need of a back mounting bracket for a kitchen drawer slide. Mine has pegs on the back that go into the cabinet back wall. What other info do you need?

How to I remove these without breaking them? How are these installed? Are they glued on?

I need to replace (2) drawer slides, one pair each for two different size drawers. The slides that originally were on these drawers were stamped UNIGRASS 6600. One slide is 19 3/4" the other slide is 21 3/4". I want to continue using the slides that were originally placed in the cabinets along with ... (cont.)

I was trying to move my cabinet drawer up and tried to remove the mounting brackets and ended up breaking one. Can't get them to budge at all. I can't find a replacement online.

I have this rear mounting bracket in my kitchen cabinets, and they appear to be missing all the screws to keep the sliding supports connected to the drawer. I'm not sure if the screws are actually needed. I am on a quest to find this plastic rear mounting bracket and read its installation instructi ... (cont.)

Hello, I'm in a months long process to replace a failed unigrass 22.5" drawer slide set on one drawer. Cabinet depth is either 22 3/4" or 23 1/2" (see photo). Drawer box is 22" to the back of the faceplate.The challenge has been to find replacement slides that can mount to the drawer box properly. ... (cont.)

Rear bracket slide brace? 3 inch x2.5 inch. slide opening is 1 inch.