Viewing all customer Discussions for:

82-089 Legacy Handle Set, 3-15/16" (1-1/8" to 2-1/2")

Looking for this patio door handle

sliding glass door handle, handle plate looks like 9-1/2 long.... no brand name on door or handle please help

Can the locking mechanism be flipped over so that it does not move towards the door frame? Our frame does not have any extra room for the latch to move that way. Thank you.

We have a Windgate 3-Lite Patio door and would like to replace standard handle with a keyed handle. Screws on handle are 3 15/16 inches apart. On inside screws are 3 1/2 and 5 1/4 inches apart.

Need help locating a possible Silverline tan patio door handle from 2007. Any help would be awesome. Thank you! Rena

Wanted to know if the product shown here would work with my patio door.

The lever on this sliding door latch does not stay on - see attached/detached pictures. I am looking for options to either replace the lever or the entire lock. If replacing the lock, ideally one with a low profile exterior handle would be preferred as there is not a lot of width between the door an ... (cont.)

Broke inside part of sliding glass door handle

Windows are 10 years old

Hello, I looking for a Sliding door handle from Traco. Have attached picture for reference. I only need to replace the back side. The length of the handle bar is 10 inch, I open to suggestions too. Thanks Jay

The lock lever broke off of the handle from our sliding door. We need a new handle with the lever.

Contractor screwed the screws to tight and my handle leading outside has snapped off. I'm having a hard time matching it up, hoping for some help. Thanks.

Is this a match?

Do you have a replacement handle that is close to matching this picture. The latch is fine, its a double hook latch.Thanks

The measurements and style of the Legacy handle set, non-keyed, is the same as mine. I only need the handles, as my the white paint on my handles have worn off, due to heavy use. Can I buy only the handles, since the rest of the set is in good condition?

Just ordered 82-089 which was recommended. Can the inside handle be reversed to pull the door open to the right? Picture looks like it would pull open to left. Thanks,Chet

Can you please help identify a replacement for this brass colored thumb latch for a sliding glass door. I am buying the condo and do t yet have access and one of the slider latches does not work and The latch needs to be replaced (or repaired) Thanks!

The lock mechanism is defective and indoor handle lock/unlock lever is broken Lock mechanism 12" center of mounting screws. Outdoor handle has no locking mechanism - Handle only. I have attached some photos. set for a Alside Model# 6106-6"

I need three sets of these sliding door handles. I believe the door was manufactured by RC Aluminum. It has an inside marking of WIPI. White3 15/16 hole spacing1 3/4 door thicknessThanks. Jim

I would like to know if this handle will work as a replacement. The new handle has the lock on the face. My handle has the lock on the side. If this will work, I would like to order it in addition to the order I placed today.