Viewing all customer Discussions for:

91-001P Storm Window Latch Set

My dry rotted plastic window screen corners broke and I need to replace them. I’m unsure of the size I’ll require. Also, the spring retainers are also defective. Can you assist me?

Hoping to get a replacement part. thanks!

To Whom It Concerns: I'm looking for replacement clips for my front door storm the clips for adjusting how far the window is open or closed.Thank you,Justin

9/16" wide 3.5" with part of the tip broken off (likely about 3.75" wide before broken) note the spring system in the device

Please identify this balance. Price? videos to replace? Any additional information needed?Nikki

Hello, Can I find these parts for double hung windows for an old hourse from the 70's.

We have storm windows in our house they have no name nothing to identify them and most of the corners are of them are broken

Both sides are broken, missing the part that sticks into the frame. The glass just got replaced so I don't want to disassemble it until I can get the new parts. These are at least 30 years old.

I'm trying to identify this pin on some old windows I have, while I save to replace them. They're aluminum windows and this current piece is metal. The pins are pulled back to raise the glass, and sit in divots that are built into the slide rails, to hold the glass up.

Hello, Looking for this storm window piece that i have attached a photo of. thank you!

Good morning, We have old, aluminum storm windows and in a number of them the latches have broken off. The corners of the windows are also separating. Do you know which parts I need to order to replace these? Thank you!

Hello, can you tell me the part or parts I need to replace this broken latch?

I am reaching out regarding the BF Rich vinyl/tilt-in windows I have, which are equipped with sliding half screens featuring latches. Unfortunately, a few of these screen latches have broken tips and require replacement. I noticed that your 91-001P window latch set appears to be a perfect dimensiona ... (cont.)

Looking to get 2 top tilt corner peices I think it is this part number. https://www.swisco.com/3-16-tilt-corner/pd/Replacement-Top-Tilts-for-Storm-Panels/95-250 Then I also need 2 corner peices that don't have the tilt tab and one of the locking slide mechanisms. Any help would be great. ... (cont.)

Not sure what door I have but the latch is very similar to the 91-001P. My question I have a broken latch Can I install new latch with the window intact? Is there any identifying mark on the door to tell me if it is a Swisco or model number

Don't necessarily need the clip loop but I want to make sure replacement will fit and is compatible. I tried to measure height while in window and seems to be around 5/16-6/16" and has one little peg off of spring that locks it into place when you slide it into window.

I'm looking for a replacement storm door window latch. It's spring loaded. The two on the bottom of the window broke. Thank you for your help.

Replace broken metal cllps to storm window on storm door with one i brought from your company. Need to replace plastic unknown items pictured above. They were removed from trim section at top of window. Those are photos showing the top with looks like im missing screws to secure frame on the inside ... (cont.)

We have a problem with salt corrosion on storm window latches. Does anyone know of a product that protects the window latch from corrosion and will lubricate the latches. WD40 is not an option as it does not inhibit salt corrosion

I am looking for window finger latches left and right hand for aluminum framed storm windows see photos attached and dimensions. Do you carry anything that could fit? Thanks, Peter