Viewing all customer Discussions for:

38-075 Truth Hardware Low Profile Sash Lock

Do you have white locks for left and right hand application. I only see left on your website ?

Replacing existing sash locks that have rotted out due to exposure to salt corrosion. They appear to be Truth Hardware non handed in bronze. They accept a tie rod for tandem application and need to have the receiver hole to accept the tie for pin.

I painted my windows and want to buy white locks. 38-075 looks to be correct how can I be sure? Windows were installed in 1997. Thanks

I need to replace two right-side operators, two left-side operators, and one left-side latch (opposite to shown in photo. One of the operators is identified as an "Entry Guard, Truth" with Part Nos. 30841L and 20810 visible. I also need to order one of your Pry Bar and Scraper Tool (#75-081).Thank ... (cont.)

Pictures one and three are what I am looking for. I posted the middle picture to see the color. It looks to be a platinum, clay, stone not sure. It is Marvin window I think. Can you help me find the same thing in this color?

Need tandem sash locks and sash lock keepers. Can you help me identify the parts I need? The windows are pre-1992 vintage.

I need to replace this latches or locks can you recommend something?Regards, Martha

Hi! We are renovating our home, which was built in 1938. We are having difficulty finding matches for these. Are you able to help us identify them and hopefully purchase more? Thank you! Jordan

Looking for replacement locks for awning windows. One of these is a Marvin (not sure which). Could you identify these, installed around 1993. I need a set- left n right- of each. Do you carry these parts, how much would they cost? ThanksNick

I. H. 2 L 5 On inside of crank. No ID on inside of latch Would like it in white.

I would like to replace the many Truth Low Profile Sash Locks (Product Code: 38-075) around my home with an alternative sash lock like the Product Code: 38-098. The handle on the 38-075 interferes with blinds on some windows and I like the lower profile handle on the 38-098 much better. Does an exac ... (cont.)

I broke the little knob and need a new latch assembly. Numbers I see on item are: 45098 P/N 31300 E CAN PAT 1980.1985 US PAT NO 4059298.4429910

Windows were replaced but not the cranks etc. Need to find complete hardware kit. Thanks!!

I need locking mechanism for this. We have 4 on bay windows

Window is 16" w x 31" h, a small casement. Opens to left. Ring gear on the operator shaft pops out. I drove it in and it stays provided the window is used gently. Believe I need the complete assembly and hope you can verify that. Included the numbered arms for your benefit. Have others but this is m ... (cont.)

Hello, I broke the lever on this lock that pulls the vertical window pane into the frame and locks it after turning a separate handle that swings the 60" vertical window out and in. Can you help me order a replacement so I can get the window working again? Thank you, Dave

Hi Mike. For your casement lock, see if our 38-075 is a good match. For your casement operator, if you just need a new crank handle, see our 39-114L.

Take a look at our 38-075 sash lock and 38-089 keeper.Compare the dimensions to the parts you have and see if these will work for you.

This looks like a 38-170 in oil rubbed bronze. The stainless steel latch on my window has a part #31359. Can you get this for me.

Top reads 31512 Bottom reads entry guard