Viewing all customer Discussions for:

39-032 EntryGard Dual Arm Operator

Hi. Included are 2 pictures of my wondow crank that needs replacement. A tooth from one of the gears broke. I point it out with my needle nose pliers. Thanks. Ted

Please help. Need right and left

When looking from the inside out , need 3 that window opens to the left and one window opens to right. Long extender bar measures approximately 81/2 inches. Can you help me out.

Please identify operators and get me price. Thanks.

I need the right closer for this

Would like to identify replacement part

I have Milgard crank out windows installed in 1996. The corkscrew mechanism inside the piece that the handle sits on top of which turns to let you open and close the window is broken. The picture sent shows the L31538 Entry Gard Truth. Do you carry this part? I am in need of two of them. Thanks ... (cont.)

Looking to find what hardware I need as our handle does not turn the "auger" to open of close the window. No clue what I need to order.

Do to corrosion from salt air Id like to replace all parts. Including the slider under the window that is badly rusted.

Hi there. I need to replace 4 of these window openers - help! The markings on them say: Truth (brand) "Entry Gard" 205544

can you tell me what i need?

The short arm attached to the gear has the letter R stamped on the top side and the number 31538A and the letter L stamped on the bottom side The short arm is 3.25 inches center pin to center pin The pivot arm that is attached to the short arm is stamped 20810 The pivot arm is 3 15/16 c to c The l ... (cont.)

I need replacement hardware for my window. Was able to see the words, Entry Gard Truth and the numbers L30841 and 20810. Please see attached photos.

this mechanism is over 25 years old. It's been working just fine for the last three years since we moved in but just failed. I need to repair or replace it. Can you help?

Hello, The worm gear that turns the cogs to open/close the window has become dislodged from its base. I see that there are matching grooves on the side of the worm gear housing and the internal aspect of the base. Can these two parts be put back together again by applying force to the worm gear t ... (cont.)

I have a casement window that needs the dual arm operator replaced (truth entryguard 30744). The window swings out and to the left + has the crank in the center (not the type that folds down). Can you tell me the correct replacement part?

Hello- We have truth window hardware (we think from the 1980s) and the small part that goes into the crank handle appears to be damaged so is no longer catching the gear properly to crank the window open. Is this a smaller part we can replace or do we need to replace the entire operator system? If ... (cont.)

I have two windows that are missing the stem, the cover, and the handle. I read a post from someone to Swisco that I may need to replace the EntryGard Dual Arm Operator, 39-031 and 39-032. I looked at it online and it shows that the long arm is 10 3/4" but mine is only approximately 9 1/2". The shor ... (cont.)

I need replacement crestline casement window operators. I've bought some from this site before but cannot find the exact matches now. I need both left and right operators. The windows are around 30 years old.

Any idea what this is and do you carry window crank. I have bought from you all befor