Viewing all customer Discussions for:

39-032 EntryGard Dual Arm Operator

hello, i need to replace the shown window crank

Hi, I'm trying to replace the window Operator the bolt's teeth in the second picture has snapped off and is stuck inside the third picture. The brand is by Allied Windows which has run out of business. Please let me know if you have this part. Thanks!

On the crank teeth shown in the second photo it says Made in the USA on the left and Truth on the right. The underside of the handle in the first photo says US patent 4,083,264 then Can. Patent 1979 on the lower left and 45012 on the lower right. The cranks no longer grip allowing one to open or c ... (cont.)

I need to replace a operator cover and handle. possible number of a 1413271242831CW. Thank You!

Good morning. The window is located in a ocean community home so rusty is an issue. I need left hand and right hand operators, tracks and hinges. Hinges for top and bottom please. It's a bay window that still has the glass sealed. Amy help is appreciated

Looking for milgard casement window operators parts number stamped on #40753 on long arm, #31538A on short arm. The subject windows are approximately 25 to 30 years old and The operators were worn out. Please quote, thank you, Tom

I have 2 casement windows, both about 20 years old, where the roller/bushing is popping out of the operator track when the arm is cranked out to approx. the center of the track. Do you think it is an issue with the bushing/roller - or something else? If the bushing, is that available by itself? (par ... (cont.)

Hello,I need a positive identification on the attached short arm casement window operators( 3 each right and 3 each left). And also need the stud bracket for a right and left window one of each 39-032 and 39-031.(for a standard window size)Thanks,Chris

Please help identify this operator.

Windows are at least 35 years old. The cranks just seem to stop working. They might've been forced. Not sure what needs to be replaced. I have two right and two left opening casement windows that need to be fixed. Do you need to see the part/ arm that opens the window ThanksCary

Hello. I am looking to replace 2 casement operators per the picture attached. Can you help me identify the correct hardware please? Thanks!

Opens and closes the window

I have this track that is similar to your 11 3/8 entrygard track. Except mine is 13 3/8 long. The holes are 4 inches apart. The end holes are 3/8 from the ends. Do you have one of this size?

I have some older windows in my cabin. They are Entry Gard cranks and the numbers I can see are 20810 and R30842. Any chance you have a replacement?

Hello, Thank you very much for your help. Would you be able to identify the pieces in the photos that I have attached? Sincerely, monica

I need 5 lefts and 5 rights.Thank you,Jim

I'm trying to get these 2 matches

Truth 20810 operator

Hello - I am trying to identify the hardware to replace broken cranks/operators. The photos show Truth and 40942 (left side window) and 40941 (right side window). I have additional photos and videos if it helps. I need 4 left and 4 right. THank you.

45x39 double awning window