Viewing all customer Discussions for:

39-050 Rack Operator with Link

is the inside of this part threaded and accept a machine serew

Looking for window cranks for 1969 Mobile Home

Looking for 1960's era louvered door operator.

No markings or numbers on the assembly.

Hi I have this half jalousie window door on my florida room and it has this built in jalouise hand crank square assembly built into the door that no longer works. I cannot figure out how to easily remove it without destroying it but the issue it is what product do i replace it with when I do remove ... (cont.)

The lower part that pulls glass open and close is broken. Could use the whole crank if available though.

The gear mechanism is jammed up, And the splines of the pinion screw for the window crank are stripped out. I'm looking for a new mechanism

Looking for the window crank assembly for a 65 Vindale. 1 3/4" center to center mounting holes and a rack that is about 5 3/8".

This is an older jalousy operator that I'm having a hard time finding. It has "1400 Series stamped into the body.

Awning crank for a 1970's window in a Florida home. Do you have anything ? Thank you. Gregg

The piece with the teeth is broken on a few of my windows.

I purchased this handle and it matches the window however it is just a little bit too small of an opening to fit cleanly over that threaded knob. You have to jam it on and even then will only go a little bit and not enough to use the tightening screw. I need an identical handle with a slightly large ... (cont.)

Both of these cranks are shot. I'm unsure of the make or year. They are out of a very old slide in truck camper. The largest one operates the door window. The window is approximately 4 ft long and 1 foot wide. The other operates the main window beside the table. It is approximately 1.5x 3 ft. Any h ... (cont.)

The pictures are of the jalousie operator I need. Also I would like to order one of each of the glazing strips, 55-029 and 55-197, to see which one will work the best. Let know if you have a new jalousie operator.

I need a replacement for this accordion window

This house was built in the 1950's and I suspect this window is about that old. Enclosing pix of location of crank mechanism after I removed it and crank mechanism. The crank stem (not sure if that is correct term) turns with pliers but does not move mechanism up and down the teeth. Can this window ... (cont.)

16w x 22h. Rivers ground off previously for unknown reason . Will not open. I would like to replace the mechanism on the left and right and possibly the operator

I have a 5 year old 32" wide jalousy "screen door" manufactured by burch, from Baltimore Burch no longer supports this product It used to crank closed and the window panes were tight to each other. Now, when cranking it to close, the crank does not dead stop and the window is left open with a gap ... (cont.)

I ordered 4- rack operators recently. I ordered the wrong operators. The operator on the left is what I ordered from you guy's. I need the operator on the right. Do you have something similar?

We haven't found any description. We guess these windows are more than 30 years old.