Cotter Pin

The pin is approximately 4and a half inches long. It may or may not need replacement as the problem is that it does not engage the top track so there is a slight swing in and out when opening and closing the door. Any assistance that can be provided would be greatly appreciated.

Trying to figure out these parts for metal bifold doors

I am looking to replace all the mounting hardware for my 96-inch bifold doors 1975ish (full-vu. Model 8433 Serial 861097 I just want to make sure I get all the correct parts or any missing parts. If any kits work, I have no problem replacing the tracks. Thank you Paul

One of the bifold doors hadn't been working. In continuously lifting it up to close it I bent the top pin (the one with the spring). The door came off and comparing it to the one on the other side I definitely need the plastic "thing" as shown in picture 21-058. The only thing I see inside the doors ... (cont.)

Hi, We are looking to replace hardware for our metal mirrored bifold closet door 3' opening. Attached is a photo of some of the hardware pin & slide. The door has to tracks top & bottom and was installed in the 1980's. Thank you. Rodger & Ivy