Viewing all customer Discussions for:

21-158 Cotter Pin

The pin is approximately 4and a half inches long. It may or may not need replacement as the problem is that it does not engage the top track so there is a slight swing in and out when opening and closing the door. Any assistance that can be provided would be greatly appreciated.

Trying to figure out these parts for metal bifold doors

I am looking to replace all the mounting hardware for my 96-inch bifold doors 1975ish (full-vu. Model 8433 Serial 861097 I just want to make sure I get all the correct parts or any missing parts. If any kits work, I have no problem replacing the tracks. Thank you Paul

One of the bifold doors hadn't been working. In continuously lifting it up to close it I bent the top pin (the one with the spring). The door came off and comparing it to the one on the other side I definitely need the plastic "thing" as shown in picture 21-058. The only thing I see inside the doors ... (cont.)

Hi, We are looking to replace hardware for our metal mirrored bifold closet door 3' opening. Attached is a photo of some of the hardware pin & slide. The door has to tracks top & bottom and was installed in the 1980's. Thank you. Rodger & Ivy

I would like to know if you have any lower guide pins that are spring loaded that will work as a replacement part for the lower track guide pin. I have previusly ordered 6 Swisco 21-049 parts (Order #2283017). Would the 21-091 spring loaded top pivot guide pin work in the lower track as a lower guid ... (cont.)

From a 45 year old metal bifold door

plastic guide runners are broken on top track and bottom track, do you carry?

Pin hardware for 8 foot metal bifold doors. Need all hardware for 2 doors

My door fell off the tracks and is not staying on the track. not sure which pins to purchase to repair. The door has a label that reads: Full-Vu Folding door Leigh Products INC. Coopersville Michigan

Building is built maybe in late 1960? I want to replace all pivot parts at top and bottom.

found similar pins but they we're 5 1/2" long

Thanks for your prompt response to my issue.My pin is 5/16 inches diameter and 5 and 1/4 inches long. The hole for the cotter pin is 2 inches from one end. Nothing seems to look like my set up, can you help me? Thank The steel pin I have is 5/16 in diameter, I see no pins with any more than 1/4" in ... (cont.)

I have a FULL-VU closet door composed of two bi-panel elements. To repair it I started to document each element: top pivot 5/16" top glide 1/4" bottom pivot 5/16" bottom glide 1/4" A very wise decision as there appeared to be only simple pins and such. Actually each of the four locations, a ... (cont.)

The top guide wheel is not able to stay up seem to be missing an nylinder and bottom guide wheel is Bent Ned a replacement part Steel Full-Vu Door Leigh Products, Inc.

Need some mounting hardware as a few pins are missing and some exist but seem to have nothing holding them in place. The tracks appear to be in good order.

Trying to figure out what parts to buy for top and bottom stationary and the ones that move also need plastic parts that go into track .basically need all the parts

My appartment complex has about 300 leigh doors, all it says on the doors is quality control approval number 559245 I need hardware kits for the pins and the bushings that slide in the rails both top and bottom

I havre a set of bifold mirrored doors, with what appears to be 21-058 as the top guides ( only they are 4 1/4" long= complete with spring clip and guide. However the bottom guide ( not the pivot) seems to be 21-049 - ie no spring and that little nylon guide - actually two of them and it i ... (cont.)