Viewing all customer Discussions for:

Door & Window

I need to replace the corners on my screens but can't identify them

Could not find any markings on the window or parts. The piece that holds the bottom of the window does not come out of the track. It looks like there is a 2nd piece that clips into it that holds the end of the balance. They are tilt windows

I'm seeking a replacement vent latch as shown in the attached images.

Hello, not sure how to measure the shoe on these balances, the picture on the website is unclear. Do I measure from the wings or in the valley? See pic to see one measurement is 1-3/16" and the other was 1". Thanks for you help!

Hello Wondering if you can identify and supply these parts. Thanks Dan

Hello, I need to replace this part on our window. I do not know the brand. Thank you.

Team, I am looking to understand, since I am not at the home, what part I'd need to eliminate this sag in the handle as shown in photos. It seems to me that the latch spring are done and it would just be the latch and maybe the spindle and it is fine. OR does the whole handleset need to or able to ... (cont.)

I found a window at one of our locations that has this plastic piece and a pivot bar. Both pivot bars on the window are broken. What kind of pivot bar do I need to purchase to fit this piece? The plastic piece is about 1 5/16" long.

Good morning, my name is Paul. I am looking for a lock set for a pella storm door. I destroyed the old one trying to remove it. Tha pix on the left showes the brass handle plates and a diagram ok what I need for the lock set I would really appreciate your help.

This part has come apart in two windows. It just seems to scrape against window when I open it and makes a noise. Do you sell replacement part that I can install into frame of window?

Comes off the side of the windows . Has a spring inside

Looking to replace my storm door handle in its entirety. It's marked as a Pado Latao. In browsing the site, the 40-049 looks close but is bigger than what I currently have (8 1/8" tall vs. 7" tall). The 40-183 sizes closer but doesn't appear to be an exact replacement so not sure. Appreciate guidanc ... (cont.)

There are three of these plastic parts on my Traco casement window. One of them is broken. They pull the window in tight when locking. I am in need of one of these.

Both, the bottom and top Have patent number 5353548 Stamped on them. The coil itself, Has either a nine or six Stamped on it.

These are the only markings that were found on this rod. Wondering if they can be found with this information. Please let me know. Thank you very much.9

Do they come with both screws??

Need 6 balances. Channel length is 27" Stamp reads 26 4 IW CMC 11

I'm looking to replace a couple of my coil balances, one is for 9 pounds and the other is for 10 pounds. They are MI Windows

Are replacement screens available for this