Viewing all customer Discussions for:

Door & Window

Need to locate window replacement part, do not know brand..

This part I'm looking for for our windw open

Window Balancers for a double hung window

Would that be 38 for 38"? Need to know the sash cams to order as well... I measured as follows. 5/8" width 16mm bottom Total height 1-1/2". 39mm 11mm depth 7/16" Screw hole center 14mm from bottom Top 22mm 7/8"width

Arms are a little less than 4" long

25 year old home: Wasco Rolling Patio Door 15557 The track folds over during patio door operation and I am assuming its time for new rollers as well. Is there a vendor near me in Northern Illinois?

In need of keyed handle set for what appears to be JW branded. I'm assuming but not sure I would also have to replace multi point mortice lock ?I think the keeper is fine.Help identifying part(s) is greatly appreciated. Thx - Rick

The photos above show the "ring nut" that does not stay in place when I crank the window closed. The crank "driver" mechanism (photo 1) is held in place using this "ring nut" screwed securely into the crank fitting (photo 5) to hold it snuggly in place (photo 4). Since the ring nut is old and threa ... (cont.)

Stamped on bar 29-5 lx cmc 7. 30" long Would like to replace plastic parts on window too.

Hello, I have a Hurd Window crank that is completely snapped off on one side. I would like to replace both as I want a cohesive look for both windows. So I need to know what would be able to replace these with - I would be happy to send measurements as well for a more accurate answer. Thank you! ... (cont.)

I think this is a Swissco window. The crank number is 30866.

Must be faceplate c-c 6-15/16" Inside /outside covers. 6-3/4" Any finish

Plastic clips to hold screen in place on crank paradigm windows

My broken window pins are 2.5" and my balance is 25" and labeled 25b

No number or brand to lock.

I have a single hung vinyl wind that needs new latches and a new pivot shoe on left side. I need help identifying what parts I need please. I have attached some pictures. This window has the spiral balance.

Could I get some help with this part that is what hold the glass in on a storm door.

The only name is a stamp 19 4 ES Caldwell

HI I have two windows that i can no longer open reasearching the issue is the balancers, both windows are Milgard. 26 4 HX CMC 11

I'm looking for some of these.