Viewing all customer Discussions for:

Door & Window

I am looking for both R and L replacement cranks for my early 1950's Aluminum Crank Windows. OG mfg on part is Fenestra, P/N 6RS-132 R, 4. It has #12-24 (not #10-32 as shown in picture) blind tapped holes with mounting dimensions (4-3/8 and 3-1/2) as shown in the picture

Balance is 27" long, 1/2 inch wide. 26C is stamped on the side.

I need a pair like these or a replacement that will work

the metal portion of the channel is 35.5 and the full length with top and bottom fittings is 37". we probably need 6-8 so we have additional ones on hand. The stamp is 35 5 in addition we will need like 10 of the little stopper things that allow you to take off balancers and remove the windows th ... (cont.)

The only numbers I can find are 3306R2H 10TL

Hello!I would like to order two sizes of these balance channels. Both are BSI and Both have the same size top and bottom plastic pieces.Size 27 inch 2630 BSI TD. ( I would like 8 of these)Size 21 inch 2030 BSI TD ( I would like 8 of these)Can you determine from photos what I need and can you fabri ... (cont.)

Good afternoonI am looking for a euro style cylinder for a mult point doorPlease see attached pictures above.Please let me know if you carry this style, cost and availability Kind Regards!

I ordered the Gray part from you thinking it would work but the shaft is wider than the original broken part as illustrated in the pic. Looks like it would work in all other areas. Do you have a replacement that would work or do I need to order counter balance's that work with the cam lock that I ... (cont.)

Its for a side mesh patio door lock that just locks from the inside

Hi, I need to source some replacement 4 bar window hinges. I believe they 10" Truth Anderberg 201 series hinges

We took these out of the windows that r currently in my home. It allows the window to go up and down, but currently no working and need to replace them. There is a #2730 on these.

I'm looking for the seal that goes between the stationary door and the sliding door. It's a vertical seal. The door is circa 1988/89

1 window has the light weight hardware. 1 has a 3 coil balance 5 have 2 coil balance. The little circular metal part on the guide shoe has broken on multiple windows. The metal and plastic have oxidized over the years and they are all just crumbling when I try to put the sash back into the frame. Pl ... (cont.)

Hello, I have windows that have stoppers for the screen so that it does not slide over to much on the opening side of the window. Fo you have parts like this by any chance? Thank you

Handle set

The roller bearing housing is 1 1/8" wide by 2 13/16" long x 5/8" thick and has a solid roller, not dished like most on your website. The doors are from when the home was built in 1979. There are no other markings on the door to indicate make or model. I have pictures to send.

I have a 1995 Pella full glass exterior door and it requires a new latching mechanism. The people at Pella called it a gear box because when you rotate the door handle the mechanism moves one rod up and one rod down to latch the door at top and bottom as well as activating a traditional door latch. ... (cont.)

I need to replace the black casement slide for my awning window. Mine is broken. I have glued it back together as you can see in this picture. I have included two pictures of the black casement slide that I need as well as a picture where it goes, and a picture of another window that is all toget ... (cont.)

Need 4 each of these

Need to match balancer red tip and shoe as well as tilt latch.