Viewing all customer Discussions for:

Door & Window

the balancers that I am looking for are off a Paramount Single Hung window. Please see attached pictures

Looking to find these sash guides and window balancer

I have Kolbe and Kolbe casement windows (house built 1989). along the bottom of the frame sill is an additional seal. It is a U shaped channel with a double barb on one leg of the U and a bubble seal on the outside of the opposite leg. See photo. Each edge of the U is about 5mm. The U chanel sits up ... (cont.)

Hi, Please see picture of our broken coil balance. I'm pretty sure this would mean we need 2 10 lb balances, possibly a left and right if they come that way. Thanks for your help, Ryan

I need these parts. Could you please give me the advocation numbers for them if you have them I'm a desperate need of them as soon as possible. I'd really appreciate it. Thank you.

American craftsman series 50 glazing bead for a patio door 6ft for side also need door handle and rollers

Looking for a Harvey window t bar 5/8 inch center to center counter hole

Hello - I am trying to identify the hardware to replace broken cranks/operators. The photos show Truth and 40942 (left side window) and 40941 (right side window). I have additional photos and videos if it helps. I need 4 left and 4 right. THank you.

Have a durabilt. 3 season porch...have to window panes on swinging storm door. The corner pieces "ears" are all broken off....the picture i sent the pen tip is where the broken ear is missing....the set screw for sash is on side ...look like 2 pressure point indents on opposite side front facing... ... (cont.)

I need (8) Channel balances for four Jordan non-tilt windows. They read: 27 4 IW CMC 11

Series 350 Side-load Channel Balance Sash Support System

Please provide the part number for the above captioned sash locks. We need one right and one left.I have attached front and back pictures along with measurements.

My sliders have this t shaped weather stripping that fits in the grooves on the frame. The stripping tee is 7.9 mm. The fin is about 1 inch high. I have not been able to find it anywhere or find a solution to put 8n its place. Any help would be greatly appreciated.

Nylon (plastic?) Angle Bracket H - 31 mm L - 50 mm where it attached to cabinet L - 45 mm socket where drqwer slide is inserted No markings on it

We manage 100+ units and one of the windows cranks was snapped off. Were trying to get the right part for this window as it can not open

this is found in an older office building. we have numerous that are broken. there are no part numbers on them and i cannot find a manufacturer name.

I cant find this anywhere.

Hello! I'm looking to replace the attached locking mechanism for my door. It says 1292 5506 6346 on the box. Any help would be greatly appreciated. Kind regards

I don't have one.

2 differest sizes 2040 BSI vl 22" including plastic end pieces 3240 BSI vl 34" including plastic end pieces