Viewing all customer Discussions for:

Door & Window

This gasket goes on the edge of 9/16" glass which slides into a 13/16" track in a sliding door extrusion. The overall, outside to outside dimensions of the gasket are 3/4" X 3/4". Do you have anything like it?

I need 4 non-tilt channel balancers size 33-3 with 34 inch metal casing

I need 2 arms like this a left and a right

Looking for replacements for the attached photos. If you can give me a couple suggestions to look at, that would be great.

Hello, I need a window cranker like in photo. I need like 5 of them Measured 4"/around 1" Let me know if the half inch would work. Also one photo has like a window closer. Please guide me to the right one.

The numbers on the side are C 11079 PAT. 4824154. It's 21/2 x 3/8 inches.

I need help with the part in the picture. I would like to order 2 wheels and two of the corner brackets that go with them.

So I was replacing the springs and then I noticed the top white part holding the spring in place is broke or gone, then the springy metal that holds the spring is missing. Can you help ID them so I can order it. Thank you

I am trying to identify this cranking mechanism, so that I might purchase for replacement.

Hi, I have tried two different cranks and neither works, adding a couple of photos Just needs to fit the 5/16 hex nut , not concerned bout folding , it says Milgard windows if that matters Thanks

Hi there! Not sure if this damaged part could be replaced or if the whole window would need to be. This looks to be like a handle of the window to help push up the window to open.

Measures 33", clip is 7/8", 1/2 inch wide.

Crank and screen

28" window balance/sash please let me know if this is what is needed.

Attached are some photos showing the shape of the weather stripping and a sketch showing the dimensions of the aluminum window frame that the weather stripping fits into. The windows are Pella casements, serial number: 806WC. all windows needing new repair have the same weather stripping. They are ... (cont.)

The one image is of what I currently have on my windows. I want to upgrade to the desired crank image. I assume I need a new crank mechanism as well as the new cover and folding crank I need to know what mechanism I need. My current windows are Crestline. Thank you for any assistance ... (cont.)

The circa 1967 Pine Craft Millwork casement windows will not crank open. Some windows won't even unlock. I am not a handy person. Is there a firm I can call for service here or near to Muskegon Michigan? Many thanks!

Customer ordered wrong hardware. Hand crank gear teeth are stripped at closed position.

I just bought a house that has two of these screen doors and I'm trying to figure out how to remove the screens so I can clean the glass. Ideas?

I am looking for a replacement operator handle for a Truth Hardware Casement Operator which has made the operator non-functional.