Viewing all customer Discussions for:

Door & Window

The knob broke off my screen latch assembly. MY Pella windows are from 1980. ..the whole case assembly measures approximately 1 1/2" wide, by 1" tall. ...The recess in which the knob fist is approx. 0.85"; the small hole all the way through is approx. 033". One attached photo shows the assembly f ... (cont.)

I bought a house with casement windows that had no crank handle installed, and no identifying features on the assembly or the window. Any help would be appreciated!

Says entrygard truth Left and right side About 23 years old

Please confirm that the proper replacement Operator for the accompanying pictured old operator (short arm 30842R,long arm R1130472) is SWISCO item # 39-032

Can you make this balance?

These windows are above a garage. They open from the bottom (not left/right). The TRUTH arms when fully extended are about 7" and the crank base area is also 7".Thank you for any help!Nancy

I have six vinyl double hung windows with various pieces of the sash balance system in disrepair. I would like to purchase 8 sets (coil spring and accessories, pivot bar, brake shoe) of better quality since the homeowner appears to be rough on the existing ones. The pivot bar is 2 1/4" long, has a ... (cont.)

Installation holes 2-7/16 width -7/8 Length 3/3/8

Hello, I need help identifying the plastic part depicted in the attached pictures. It is for a Milgard single hung, non tilting window. I recently purchased two Chanel balances for this window and discovered I am missing this plastic part which sits in the channel on one side of the window. Thank yo ... (cont.)

Hi. We have a truth 30744 casement window crank that need replaced. See pictures, Pictures show the 1 window 2 A good crank installed on a different window And 3 the rusty part we need replaced on a broken window. Please help us order part. Thx

How do I find this

Need to replace the bottom rollers on an old sliding closet door. The back of the door had the name Gardner Mirror corporation But I don't think that means anything. Would you have replacement parts that look anything like this? Thanks.

Hi I'm Mrs Ali I was wondering if you sell the two side molding of my frame of my entry door we ordered In Home Depot but my dog when she was a puppy chew the insulation That's my entry door thanks

Need to order a replacement

These are shots from the exterior looking at the latch from outside... I need the whole latch assembly, assuming any available...

Please see attached photos. Need assistance identifying replacement balancer parts. Can see patent# 4610108 and another set of numbers on third photo.

My 24" spiral non tilt balance has a hook on the end. Don't see it in the list

NEED ROLLERS

I'm seeking a replacement channel balance as shown in the attached images

Thank you for your response to my inquiry. please see the attached pictures. The door will not stay locked when the handle is turned upward. The Plate attached to the door's frame measures 6.5 inches x1.25 inches. Thank you, Darrell