Viewing all customer Discussions for:

Door & Window

Looking for parts ..attached photos Need left and right.

Trying to identify this part

DOOR IS A Series: Legance 3 Patio Door

Replacement? AW 2573563

I have two double hung windows from IWC, installed in 2008. ALL of the pivot bars have broken. (The company went bankrupt and doesn't honor pre-bankruptcy warranties.) My busted pivot bars are 2.75" long, so it looks like I'd need either part #26-360 (2.5") or #26-415 (3"). There should be room ... (cont.)

Hello Swisco. I ordered coil Balances in the past from your site (S152-6) and now I need some shoes, coils, and coil bushings. looks like I need the 15-180 Shoe but some of the responses that I read state that I should be using the Series 190 coil balances. Is that correct? Also which coil bushin ... (cont.)

I'm looking to replace my window latch for my tru-view windows which were installed in 1993. Do you know where I can find any of these?

I need to replace both of them. Thanks Frank

Hi , I am looking to get a new lock and keeper set for PGT sliding door. As there are 2 numbers written on both sides of the lock , I am not sure which one should I look for to look for parts PAT #5.820.170 PAT #6.264.152

.need a new door handleJoeDoes the 82-030 look right?

Looking for replace for cole Sewell storm door lock set model 06049896042Door is 1" thick outside door plate is 9 & 1/2" long

I am looking for some replacement tie bar guides for my Certainteed casement windows manufactured in 2003. the only identifying marks are a crown molded into the lip that surrounds the tie bar and four screw holes, of which the outer two are used. width not including the screw holes is 3/4 inch an ... (cont.)

Balance is a Caldwell 1/2 Channel and 8" in length Hard to read stamped number looks like 12 Caldwell hard to make out.

Hello, I have old acorn windows and during storms the whole track fills with water as seen in the images.. This is just the remainder 2 days after soaking the rest out. When the whole cancel was filled. Curious how to prevent this from happening and if I'm missing a necessary part. ... (cont.)

Help Identifying Manufacturer or OptionsHello, I have vinyl single hung double pane windows. The bottom sash part in some (meaning the part I can remove and that raises/lowers) has condensation between the double panes. I've tried identifying the manufacturer by inspecting the windows for markings, ... (cont.)

Here are pictures of the broken latch we have for our windows. The broken tip on it, that holds it in is an angled piece so it can be pushed into place. We need several of these (both right and left). Thank you

Please let me know if you think product code 40-097 would be a match for replacement. The measurements matchI would need black.Thank you.

I want to replace the existing door handle (photos below) With a handle with an exterior key locking mechanism like the one you sell. I need one that is compatible with Millard Tuscany series 1" overall dual pane sliding glass door.

the code on the balancer is 16C 0d BSI as it shows in the photo. i need both sides since i will have to replace them both. i can go with any compatible products of yours if the same ones are not available. I have no way of knowing what brand widows are they.

I am looking for 2 Balancers along with the plastic brackets on the window frame for the pictures attached. I don't know what model it is.