Viewing all customer Discussions for:

Door & Window

Please let me know what other information might be helpful to identify replacement parts for these. Thank you-Dennis

I was able to buy these years ago, but can no longer find them. I saw a post you responded to that showed a similar part but it wasn't quite the same as mine with the 2 screw holes on the top. Any chance you have something similar? Thank you!

Hello, I have what appears to be a Caldwell series 300 window balance. I am attaching photos of the ends and the stamp. (metal channel measures 26 inches).Can you recommend a replacement part?Thank you,David

The balancers are 29" long (Metal portion). The markings on the metal say 28A with 06 in small characters after the 28A. These balancers do not have wings. The door was made before 2008 (already installed in our house when we made the purchase). I found the following info from the Larson website fo ... (cont.)

Hello. I am looking to replace the door handle, outdoor pull and latch. Will item 82-020 work? The length from the black pierce to the handle is about 2 inches instead of 2 1/2 inches and the outdoor pull is 7 1/4 long.

Attached are pictures from my sliding glass doors. I have been unable to locate specific replacements. Each piece is about 2 3/4 by 1. Any heop is appreciated.

I need the attached door handle. It is broken. Thank you

Door latch handle to sliding glass door is broke.need replacement part

Hello,Below are the parts needed and quantity with each picture. Once part numbers are confirmed along with price we will start a business account.Please call me with any questions.Quantity (2) - 3 5/8" rollers - please provide part # and per unit cost.image0.jpegQuantity (1) - 3 5/8" I believe part ... (cont.)

Will this pivot bar work for a spells Envompass window- it looks very similar? are there secrets to Replacing? Thanks Tim

Hi, we need replacement Storm window tracks as shown in attached pics. Thank you, The shaft is square, 3/16x3/16. And the guide is 5/16 above the shaft. The guide itself is 3/16 long and is rounded. The total length is about 1 3/8. See additional attached pic Thank you 70-020 doesn't look ... (cont.)

about 21" metal channel stamped 2090 C on side

Small block that sits under windows and elevates when closing. I am also looking for the lock mechanism

most of my double hung tilt in windows have broken balances. The metal assembly is pulled away from the T channel stop. I want to make sure I get the correct part. they are 28C assembles and look like 795 series. I would need 16. The attached pic is of the stop which looks slightly different the ... (cont.)

Please assist with confirming which channel balance I need. Marking: 18-5 GE5 CMC 75 Length: 19 inches Width: 0.5 inches

I have to match an old wheel for a sliding glass door. This wheel has a angled slot. In which the wheel can be adjusted. The slot is open at the bottom end and the wheel doesn't look like it's fixed. It keeps falling out when I try to reinstall it. Anybody know anything about those? I believe it's o ... (cont.)

The lever lock on the inside of the door malfunctioned while the door was locked. The screws to the handle are not accessible. How can I remove the handle so I can repair OR replace

Handle says I have an Acorn DorWall. I'd like to replace with double rollers if possible. 1-1/4" concave wheelThank you,Glen

I am looking for the crank unit and handle connected to the sill. Gear system busted.

The window channel mechanism needs to be replaced. The window is Ply Gem 1500 series Single hung CDP# PWG-M-170-00023-0001 R-S0-3575379-3-7 On the mechanism the identifying number is 32 B. Thank you for any help with this!