Viewing all customer Discussions for:

Door & Window

Good Morning,I'm looking replacement tilt latches for Silver Line windows. The existing latches have no product number. They are 2 5/8" length, the width is 11/16. Could you please let me know what product I need.Thanks,Ann

Do you carry this type of rollers ?

28 nollands road fiddletown, 2159 sydney, Australia

Please let me know if you carry this type of replacement latch.

I need only the handle piece -- all other parts are fine. Inside it says "made in New Zealand". 4-15/16 screw hole spacing. Is this something you have? I do not know the style name of the door. I hope you can help. Thank you

Can you help me identify the best parts?

Please help identify which channel balance I need. 36C BSI is stamped on it. Some say 36B. Is the coil a seperate part?

Looking for a replacement part for a Caradco Window Crank

Hello Looking for this pella window lock

Am trying to find what I think is the pivot shoe for my window

Window pivot shoes left and right for a vinyl replacement window. These shoes have a piece of metal attached which acts like a spring to give tension when opening and closing the window. The other picture is from an Anderson window that is approximately 25 years old. It is the window lock. Could yo ... (cont.)

Hello. The handle on the lock on my window snapped and I would appreciate some help in finding a replacement. I'm not sure who manufactured it but I think that it might be made by Truth (the window crack is manufactured by them). I also uploaded a photo from a different window showing it installed. ... (cont.)

Please help...I purchased several simonton ultimate 9800 series windows and 3 balancers top and bottom are broken where the cam attaches. Each window is 31.5x59" and will need 12 total. I am having a very hard time finding these pieces online and just want to be able to open my windows without havin ... (cont.)

Housing is 3.25" long x 1.5" high. Wheel diameter is 1.5"

Hello, the mounting plate shown here is the part i'm looking for. The inset screws are 4 15/16", then the 2 screws for the handle itself are 5 3/4" part. Please pay close attention to the last photo, "06717dc7-f6de-...", which shows the mounting plate from the side, so you can see the holes that ar ... (cont.)

What parts do I need to repair these MW sash lifts? The windows are from 2000

I'm not able to get them out of the window since they are broken. Are you able to determine the part I need with the stamp?

I see no numbers or information about the window manufacturer. I can see that the bottom of the plastic window piece, that has the spring attached at the top, has broken off. If you don't have exact replacement tracks are there any other alternatives? This is for windows in a cabin that is only heat ... (cont.)

Hello,We have older American Craftsman single hung windows series 350. We need to replace the tilt latches on 4 windows.Thank you Chris

I don't see any names or numbers on my existing wardrobe door wheels but I have included two photos. The plastic wheels are broken. There are four of them. Can you please assist me in ordering replacement parts. Much appreciated.