Viewing all customer Discussions for:

Door & Window

The channel balance is roughly 27 inches without the end caps. Has 26 2 ft cmc 2 stamped on it. Roughly 5/8 wide

Trying to find replacement parts

Looking for working replacement. Screw holes are 2 1/2" apart. Total length of latch is 3 1/2". Any help would be greatly appreciated.

Trying to find a replacement

Looking for the replacement wheels for my sliding screen door

Hi, the gray piece is missing on one of my CertainTeed double hung window which causes the top sash to drop when unlocked. Please help identify what piece that is and a replacement. Thanks

Could you please tell me what part I should get to replace this Truth window hardware from my daughter's window. It is stamped into the metal with Truth #45251 and also has #4122001 0222 stamped in ink. I do not see an exact match so I am assuming this was discontinued. I'm trying to find a replacem ... (cont.)

Need to replace above for back sliding glass door, home purchased back in 2007.Please let me know if you have it or when can I obtain it at.Thank you

Need replacement storm door black push opener. The back of the mounting piece (on the silver ring ) says "DBL 1200 on it. And it also says Wartin Co by the handle. It's a heavy little piece.

handle is 4.5inches long, and 1 inch wide at widest part. Do youy have a handle replacement, or would the entire assembly need to be replaced?

Lock number is 45226. Latch is 1/4" thick.

I need to indentify this entire window crank. I tried researching using what was on there but I could not find it

Can you give me part numbers for these 2 items? Then i can finish my order. Thank you, James

I have several vertical sliding windows from the 1990s. They are double-pane glass windows, with a screen either between the panes or, in some cases, on the exterior side. The window balance on the lower side is broken, so I can no longer push the window up and have it stay in place. On most of the ... (cont.)

I need a new crank for my JAL-O-VENT window that was originally produced by IECO industries DesPlaines IL.

Looking for 50 each of these kind of locks.

Hello, Here's the best photo of the existing balance. Unfortunately we have not removed it. From what I've been told it appears to have been a Caldwell Ultra-Lift CA-85-22R because it is 22 in long and needs 30 lbs and is 9/16 wide.

Hi, We need a single part for a sliding door handle replacement. The distance between screws is 5 5/8" Thank you!Oscar

We need to identify the parts so we can order them.

Good Morning. My name is Joe and I'm looking for 2 different storm window corners. Attached are photos, including measurements, of the two corners. I have not been able to find them online as of yet and was hoping you could help me. Thanks in advance.