Viewing all customer Discussions for:

Door & Window

No markings found .The plastic retainer on bottom of spiral balancer.Thanks Dave.

Refurbishing my 43 year old Truth windows. The house was built in 1980 and I assume they are the original windows. I would like to replace the weather seal as it has disintegrated on most of the sashes. The attached pictures show that it is about 3/4 of an inch with a 1/4 deep kerf thingy (my tech ... (cont.)

Arm and crank of the window is broken and I need a replacement part that suits this window.

Inside door handle on my Cole Sewell storm door does not spring back to a horizontal position so that its nose sits against the vertical bar attached to the door jamb. From what I have read, it looks as if your 40-150 model might solve my problem. The outside handle seems to be working properly. ... (cont.)

Looking for replacement counter balance's for my 27 year old Anderson window

Channel balance series: S751Channel length: 57 3/4Channel stamp: 26TGQuantity: 2

Hello. I need a window balance. I've attached a photo of the ID label of the window.

Hi This shows the broken clip sitting on the white painted portion of the window. The crank is still working. The only way I can close the window is to remove the screen and pull in with my fingers. Yes windows need replacing. These Anderson windows are on the back side my 1783 house. I am working ... (cont.)

I'm wondering if you carry the replacement parts for this style of window.One has a broken arm on the outside of the window.Thank YouMike

Hi Swisco I am trying to find a replacement for the part in the picture below. (finger pointing to it) It is the part that attaches to the window. The windows came from window wizards in 2009. I would need a left side ( pictures are the right) Thank you

I need both the left and right window balance mechanisms. The metal channel is 19 15/16 inches long. The lable/mark on the channel 19 3 GR Caldwell pictures attached.

I found markings 793A and 793B

window vinyl needed - please quote

I had a Legance 11 patio door installed in 2002. It has become hard to open and it was recommended that I have the rollers replaced. I have some pics of the labels on door frame that I could send.

Hello, I think I made a mistake in ordering a replacement part. The one I received is not the same as the one in the picture above. Can someone please help me order the correct replacement assembly>

I am looking to replace the existing lock set on our Milgard 86OX sliding patio door. Current door only locks from the inside with a push handle. We wish to install a lockset that is keyed from the outside. I have attached two photos of existing lock. Door is 1.5" thick and existing hole centers on ... (cont.)

Aluminio e Screen Door Latch

Need help getting a matching part for the other side so that window doesn't slam down right away.

Simonton Slider - Your part 81-158 looks the same, the measurements are the same, but the wheels we have our 1 1/2" in diameter, the wheels on the replacement part are 1 1/4" in diameter. Will the replacement part work?

Hi, Hope all is well. Do you carry a similar looking style of handles - with 4 15/16" CTC. Regards, O & J Doors