Viewing all customer Discussions for:

Door & Window

¿Could you help me please with the model / item of this screen mesh? We have to change in several windows, and we want it to be the same Regards, Marcelo

These are for a small 24"x36" DH. I would say approximately 15-20 years old. They are 1-1/4" wide and 2-1/2" long. I have a pic.

Hi, I was hoping you could help identify this double hung window manufacturer, hoping to get some replacement Sash Pivot pieces. Included other parts from same window that might help identify the manufacture. The Sash Pivot rough dimensions as follows: W 3/8" H 1 7/16" D 1/8" Pin Height 5/8" Two ... (cont.)

Do you have the associated dummy handles? Would this work as a dummy handle

I am trying to order two block and tackle window sashes size 22 inch for CWS windows

I'm trying to figure out what part is right the pella sliding door lock thing broke can't find paperwork to make sure I order the right one to replace it

We need to get 2 of these for our window not sure if size it says 31" On the bar is says 3090. oj34

This seems to be a block and tackle around 24 inch what replaces it

I can't get a good picture however the house was built in 2014. I know it's Penrod as the hinges have it's name. It has a brown sweep. I couldn't get a part number from their site. Thanks! Rob Handyman Services. I have purchased items from you in the past and found you to be very helpful! ... (cont.)

Lock fell inside door so can't show out of door. Door is from 2008. 45 degree. Took pic of inside door also attached. Need to know which would be replacement.

Need to order 28" long window balances

Just want to order the right replacement parts. Balance length appears to be 26-1/2 inches and has markings saying 26 and another saying 4 bsi PB. It appears that the 26" Series 385 Channel Balance most closely resembles the current ones.

Hello, In need of a replacement handle. Manufacturer is believed to be Anlin window. Thank you

I am trying to find a replacement handle for my sliding patio door. I am having no luck with the Imperial company. I have included pictures of the handles themselves and hardware from the door latches. Thanks you

Attached are 5 pictures showing my current latch. The latch is slightly bent due to the failure of the t-lock shoe, resulting in the release of the channel balance which then was restrained by the latch causing the bend.I determined the shoe to be 15-194.I have reviewed all the 2-5/8 latches of sim ... (cont.)

Hello, I need a couple new Balances for my 48x48 Pella/viking window. I believe it is Pella because the window latches say that, but the old receipts I've found show viking. How would I order these?

Hello, I need a replacement for a plastic balance clip/guide. Hope the pictures are helpful Thank you, -Samantha

Hello, I have pictures of a 24'' balance, I need to replace the set of them. Thank you! -Samantha

Need 10 windows they have old balances. Tackle and rod type.

Looking for this screen corner - Thickness is 5/8" Length of the corner is 3/4" Width of the end pieces that go into the screen frame is 7/8"