Viewing all customer Discussions for:

Door & Window

There is mark of "AW" on the lock itself.

Looking for sliding glass door rollers. Pull handle says international. Looks like nylon concave wheels. Thanks

The gear broke but doesn't look like I can replace just the gear. The handle says semco. If you take the cover off the assemble it says truth on one side and PAT NO 4,840,075.

I need 2 of each please. What would be the part numbers?

Small windoww, 15 inches wide by 13 high measured at outside of window frame. Would need four of them. any thoughts.

Do you carry any parts for M&W wood sliding doors?

These are metal clips that hold the glass in usually there's four and then you would glaze on top of that, but I can't find them anywhere

trying to figure out the correct bead to replace on my windows... can not find any markings on the windows..I think these windows must be original windows in my house and it was built in 1998

The Caldwell block and tackle channel balances in my "NAMI" windows have had the string in the system breaking recently and several of them have recoiled upward so strongly that the balances have completely broken off the plastic stop part attached inside the window frame at the top corner on each s ... (cont.)

I need corners for screen door slider they are 3 3/4 by 3 3/4 and 1/2"thick

What is the proper replacement for this lock? I've included the measuring tape and it looks like the screw holes are 2 3/8 on center.

Hello I am looking for a right hand & left hand window operator. Your 39381. & 39382 look very close to what I need. I have a truth entryguard and the number on the body is 45275 the short arm is 31504 and the long arm is 31503. On the left one the long arm is 31506. I measure the long arm a ... (cont.)

what part is this? Can't seem to order it anywhere.

Metal channel is 27in. long. Stamp is 26 3 rj TSE Installed by Cascade windows in 2006. Need 4 channels.

CAN YOU HELP ME FIND THIS PART NUMBER ITS FOR ONE OF MY CUSTOMERS PLEASE

Only see stamp 123 on side

Looking for replacement sliding glass door rollers, bottom edge seals and rubber plug door edge bumpers.

Note: the mechanism works but handles have broken off.

Hi I need valances for my mastic windows. I have attached pictures of the valance and the latch (broken). As well I need a replacement molding as pictured In the picture of the window. That is a bathroom sized window.

single sliding glass door