Viewing all customer Discussions for:

Door & Window

Hello - I'm looking for a replacement of the crank mechanism for a Truth branded crank on an awning window. I don't see a part number on the mechanism. When closed, the end-to-end "width" of the arms is 21.5". And, the color is sort of a champagne metallic type paint. Thanks! Mike ... (cont.)

I would like to replace operator that opens left from outside and to the right when viewed from inside.

Will crank open but when trying to close the middle part backs out and will not operate the window to close.

I am trying to find the two screen retainer clips for a Cole Sewell Storm Door. The door has a top screen with a sliding glass bottom panel. Thanks.

I don't know what post means

Please verify my measurements. Also what is the cost for 2?

Small black plastic part that slides into groove at top of window. Seems part holds the top pivoting corner in position for sliding pivot.

I would like to purchase balance for a Milgard Double Hung Tilt Window. See attached. Please advise. Thank you.

Please see attached and let me know if you can help or need more information

I need 2 of these The number stamped on the shaft is 27B

If I send you windows model details can you send me the actual parts or any body come to fix the 6 window.problem only bottom part falling down

Hello, I'm trying to identify the broken door handle on our cornerless sliding glass door so I can purchase and install a replacement. Attached are photos that will hopefully help with identification of the handle. Note that "SGDH-4" is inscribed on the inside of the handle. Thank you.Mike ... (cont.)

Hi I'm trying to replace my casement window mechanism as its broken and won't fully open or close. Please see photos attached.

My part looks most similar to the 795 however the receiver at the bottom of the channel that holds the window pin does not come out. Please advise.

Picture of right hand operator. Left failed.

One of the hung window balance and I believe what is called a sash cam are broken. I would like to replace both sides parts. But I unable to identify the exact parts. Pleas help, picture attached. Thanks

Please help me identify my channel balance. See attached photos. The length of the channel portion without attachments is 21".

looking to replace several of these and want to make sure I have the right one. Thank you for your help

I am looking for replacement parts for these. The metal body's length is 27". Width in the inside is around 1/2”. The spring is 13.5" long. The white part near the pulley's measurement may not be accurate as parts of it had snapped off at some point.

Need help finding this balances