Viewing all customer Discussions for:

Door & Window

This door is at least 40 years old and needs a new inside handle. I will purchase a intire assembly if available.

looking for lower screen door rollers for crestliner model 941 patio door sgd-r35-72x72

Need 3 replacement parts- thank hou

I need to purchase two of these plastic parts. There's one on each side of the window, they latch onto the balance.

I am missing this bottom bracket for a wooden bifold door. The bracket would be at the bottom left frame for a single bifold door.

Hello! Please can you help me identify - and send me! - the parts I need to repair the broken spring you can just see in these photos? Thank you, Tim

I need to replace the crank for this window. Do you have the replacement parts

Looks like 5 1/4 inches long on the top, bottom is open to cover hardware, hole is in the middle towards the bottom of the top part, top part is between 1 1/4 to 1 1/2 inches wide. Not sure what brand of windows. They were put in with the Detroit Metro Airport Quiet Home project in 2004. I was to ... (cont.)

Straight arm is 5". Elbow arm is 4". i am looking for both right and left hinged.

Hi,I am looking for this part.My Name is Ghodi I have a glass shop in seattle.Best Regards Ghodi

Knob and rotating screw post separated

The coil snapped on our kitchen window 24". Not sure what balancer size to get in replacement.

This is a clip used for fake windows installed on the exterior of a building. There are no markings or model numbers on it and we'll need either this exact piece or a similar product that can be installed as in the picture. We could not find replacements online that looked like this piece. We are an ... (cont.)

Good morning! This part is a roller on a sliding patio screen door. I'm not able to identify the part number or manufacterer of the door or part. Respectfully, Nathan

3 inch brass pivot bar for vertical slider. No identifiable markings found

The pivot lock is 1 1/4 inches wide and 9/16 inches deep.

See photos

Coil spring balances. The number 35 is on one of the coil springs. There are 3 springs.

hardware falling apart

I have these rollers that I have never seen before. Would like to get 8 of them if possible.