Viewing all customer Discussions for:

Door & Window

Hi looking for two sets of channel balances plus the window part that holds the balance in place as shown in the photos attached. The windows are single hung. They seem heavy.

Window broken handle

None

Hi I have these windows and they crank open. One of the windows arms that pulls and pushes the window that's attached to the window snap. I've taken images and one with the tape measure let me know if this can help or do you need something more specific to identify the window parts. Thanks in advanc ... (cont.)

This seal fits at the top of my bottom pane and sits against the bottom of the top pane when the windows are closed. I believe this is considered a kerf.

Not sure what this clip is called. I am in need of six of them

It has a part number on it 1528 and also 1463. I attached a photo in the messages. It is the exact same size as the the one I searched but it has quarter inch stops sticking out on each side

Trying to find window parts for windows installed in 2000 by builder. Balances, Shoes, and Pins.

I was unable to post photo. clip is white plastic or nylon about 1 1/4 inch in horizontal dimention. Clip has 4 holes, two of which are screw holes to attach to window frame. Clip holds long vertical metal latch bar. Bar is 1/2 inch wide

Not sure of the window brand. The shaft is 7/8 inches long. 3/8 inch splines. Haven't seen a handle that fits the shaft with 3 splines.

Looking to identify this trim piece so I can order another one and two handles that go with it

I have a few broken window shoes that I need to replace. I was wondering if you have these in stock or something that would work. Measurements are included in the photo. Thank you

Looking for 2 dasher keeper springs for a Series 2222/2230/2232 Hung P.L # 466-003

I couldn’t find the exact name or brand of my window, but the size of the broken part is approximately 2.3 inches x 0.9 inches x 0.5 inches (the largest rectangular dimensions).

Good morning, My name is Joseph. I'm looking to get this roller if you can identify it and have it in stock. If you could please take a look at the pictures and see if you have this one in stock, I definitely would like to get the replacements. Thank you and I look forward to hearing back from you ... (cont.)

Are the 747 t lock open cams universal? I know you don't sell but will any 747 open cam t lock fit? The tabs are broken that lock into my recessed groove on the channel.

Please see attached pictures. Need the following items Qty 2 Pivot Lock Shoes, Qty 2 Tilt Latches, Qty 2 Sash Pivot Pins. Pivot pins are missing on both sides of the window hopefully you can suggest a replacement based on the Pivot Lock Shoe pic?

Looking for a replacement

Original 60's era heavy aluminum sliding glass door. Need to replace rollers pictured. No markings on door for manufacturer or anything else. Roller says 'General Bearing Mineola NY'. Roller wheels are 1 11/16 inch diameter, and 7/16 inches wide. I think with a 1/4 inch roll-pin axle about 3/4 inch ... (cont.)

Thx!