Viewing all customer Discussions for:

Door & Window

Dear Customer Service,I would like to purchase a new IWC Sliding Door Handle to replace the broken one. Please let me know the part number and how to place the order.Thanks,David

Trying to find the replacement parts for my right side windo .

It measures about 3/4" wide and 2 5/8" long.

Has a number 4 on one side it's for a ensure window

Good morning, Can you help identify this part. I do not know the brand of the window but I noticed that the arm that swings the window out is Truth.I also need to replace the cracked handle and cover.Thank you

Looking for replacements do you have any suggestions thanks

This part you have to put four two on each side to keep the window straight

These pieces fell out when pulling out window to wash it. Also bottom left dropped due to piece not holding it in place when popping window down to wash

How can I can a replacement for that part?

I need six, 30" window balance. Please see the attached pictures.

Vantage I Casement window 287-N-022 When opened more than a few cranks, the push arm falls out of the little plastic slider, and the window will not open or close until the arm is manually re-inserted into the slider. The installed picture is looking up at the bottom of the partially opened window, ... (cont.)

I have some Ultramax All side vinyl double hung windows from right around 2002 that I need three different parts for one the exterior weep holes also interior, locking mechanisms for maximum height of raising the window. also pictured I have the devices that sit in the track that except the bott ... (cont.)

hello we need a sash pivot bar to fix this double hung window

There is supposed to be a small plastic wheel on the pin that fits into the channel on the window part of the crank mechanism. It broke into pieces. Is this wheel replaceable? Or is there a replacement for the whole crank assembly for this window? I don't know what the manufacturer of the window was ... (cont.)

I need a set (L+R).

I need the whole part

I am trying to replace the entire crank unit

I need at least four replacements for these old casement operators be awesome if you guys could help us I can get more photos but I have included the one photo that I did take. Let me know if you need any more information thank you, Chris

I need help with getting parts for this operator, I need the sliding all of the parts including the part that attaches to the bottom of the window. Thanks.

The bead is 3/4 by 5/16