Viewing all customer Discussions for:

Door & Window

Can you help identify the post and glide? See photos glide 265D stamped. ThanksGreg

This is a corner key of a aluminum frame storm window. The slide bolt passes through it. I can't find any marking on it.

Need to find replacement part for bottom of Crystal window

Hi I am looking to replace the door track and wheels for my Simonton patio door. The track is coming off from its place and also the wheels are not gliding over the track.

Looking for parts for spiral balance system need spiral balance retractors and the lower pivot guides for republic widows were made in 2000

I need to replace a few of these.What part number is it?

Looking for these 27"channel balance amd tilt latch pairs. Did not locate in your catalogue

I have tools to replace parts for Harvey windows.

Need help identifying the part number on these sash balances

THe part number is located on the photo with the white paper under it. You have to blow it up to see it. I see the stamp Andersen Corp on the bottom right and below it, I see this "C9 6#23 1-85 I need two of these. I may need more. I am assuming they are the same in my other wondow, that is the ... (cont.)

Allows window to open to clean outside

Need two new spiral balance holders 570G is on the part. Windows single hung flip open purchased 2005 at home depot(we think).

Window crank handle pin sheared off from over turning it

I'm trying to find a replacement handle for my sliding door. I haven't been able to identify the door manufacturer...but I think it might be an Anderson. The handle has mounting holes measuring 5-1/2in on center. I haven't found anything in my area, so I want to make sure I have the correct hardware ... (cont.)

left side lower pivot bar for double hung window tiltable

I have a half-inch wide channel balance that is 25 inches long (exluding the end brackets) that came out of a non-tilt window. I see a couple of balances on your website that look very similar, but am not sure which one to select. There is a stamp on the back with the letters "24 3 EJ". I have attac ... (cont.)

See attached pics: 28B and 28D I have six windows and will need: 12 balance rods 12 clips 12 plastic stops

The only marking is on the channel "28C." This is from a double hung, tilt inward, window. The chord on the pulley system inside the channel broke so I am looking to replace.

Hi, Your company always bails me out when I need parts, so here I go again. I require a replacement, locking, handle set for a sliding glass door. Easy so far, however , the screwset to attach has an offset of 5-1/2" (MAYBE 5-9/16) please see attached. I can't find ANYTHING, ANYWHERE with this size. ... (cont.)