Viewing all customer Discussions for:

Door & Window

Hello, This spring sash channel is 26 1/4" long by 5/8" wide and 5/8" tall. Please advise on the best replacement. -Tom

Hi, Couldn't find # 2417 on your website. Hopefully, there is a substitute for this one, attached is a picture. I measured and the length is 25 inches... I will need 8Photo attachedThank you,Julie

I like to buy the window rollers for my window, amounted with double side tape to the bottom of the window frame

This part goes on the top left and right side of the Chanel of the operable sash of an older aluminum/metal window. I believe it operates as a lock and holds or engages the balance. It is plastic and if possible would like to find some in white.

The plastic "shoe" is worn. Thus the window drops out of it track.

Hello, I believe I've identified this part as the S390, but could someone confirm, based on the photos? The width of the channel is just over 1/2", and the bottom shoe appears to be 1 1/8"- if I've measured correctly. Thanks, Marie

Top sash guide, not sure of 5/8 or 1/2, no other dimensions....

To Mr Finder of part-I have a ?encore forever? storm door- I may need a replacement part, the knob assembly (part #: 6892). I would like to know if you can help me locate this part? I purchased the storm door back in 1990s. It is the 36x80 size door with white color and knob assembly is black w ... (cont.)

Good Afternoon. I believe I need a couple new pivot bars or pins. My existing pins have rusted, so there is nothing to hold the window sash in place in the lock shoe at the tilt point. I have included pictures of a couple of labels on the window sash. I do not have any information on what kind o ... (cont.)

I need 2 of these. The writing on them is 28 3 80 caldwell

Yours looks like it will fit. I have a Harvey door and my handle broke. Would your work?

Please see the attached images for the information on the balancers that I am looking for. These are the parts needed for the A-1 cleaners window sash. One balance and 2 balance clips for an operable sash. No glass needed. It's a Boyd window. Have hte measurements for the balance written on the tick ... (cont.)

I have pgt windows installed my Az sunroom,wind blew out a few panels I need a latch that helps get the window and a litle white plastic pin that goes in the slot as your fitting the window in.Can't take pictures don't have a phone that does that.When you push this thumb latch the white litte pin ... (cont.)

Trying to determine what vinyl glazing bead is needed. It is a Ryan Home built in 1992. I haven't taken the window apart yet, but if I need to do that I can to try and get more specific measurements - just wasn't sure if it was a standard part that was easily identifiable. Thanks! ... (cont.)

What size do I need to order

29"I need 2 pairPlease advise me of exactly what I need.Thanks so much.David

Can you help me identify the correct parts.

Hi. Not sure if these pics will help, but it's worth a shot. I need a replacement operator (I think that's the term) for a 12" awning window. The current piece looks kinda like your dual arm operators, bit the overall length is approximately 12" (when window is closed. The window, 11 years old, ... (cont.)

vertical sliding window--please confirm the part we need before I order--thank you!

Hello, I am looking for a replacement foldable crank that would fit my existing Jen-Weld crank assembly. Pictures attached.