Viewing all customer Discussions for:

Door & Window

Old and brittle, pulling away from windows and getting twisted. Need 720 inches.

the balance rod is 3/8 inch diameter , with red tip and 29 inch,s long

From a 1965 Marlette mobile home. Nylon piece for a crank system. See photos please.I need 30 of them.

These ?plastic pieces, when turned, latch the screen into the frame. For some reason the 2 on this screen (last 3 pictures) have snapped off. The first picture is from another screen....what these should look like. I've been to a few "window" places and several hardware stores. No luck. I think, if ... (cont.)

We have several Viking windows in which the is part has failed. We have different numbers for different sized windows of 2230 and 2830. What do we replace these with?Thanks Ken J.

Hi, I'm attempting to replace the hinge pictured. I purchased 39-155 but the pivoting length of the upper arm was too short. Everything else seemed to be the same

I need new channel balances for a DIY project. I have two different sizes: 23" shaft length with 22E stamped 29" shaft length with 28 D stamped. Both have the same top & bottom pieces as shown in the attached pictures. I need to order 6 of each, and want to verify that I am ordering the correct re ... (cont.)

Picture of left side of window shows small triangular piece that juts our. This holds the left side of the window in place. Picture of same window right side does not have this piece. Part of window on is not secured in place. This is the part needing replacement,

Do you have this tilt-latch in stock? So the existing tilt-latch is about 3 1/4 x 5/8. Thank you United Glass & Architectural Metal

The Twist mechanism for this lock is missing the only initials we seen on this was A&W I'm not sure if you guys have this part or not I did look through your catalog and didn't see anything

Do you have anything similar? I believe the term to describe this is a gliding patio door thumb latch.

Is there anyway you could help me with finding these. I'm seeing similar ones but none that are exact.

Customer,Looking for (4) Lock and Keepers for a casement window per the above pictures.Please let me know as soon as possible if you have these and how quick you can ship them out. Thank you, Ron Project Manager

I have looked on your site for this material, but was unable to find it. I am hoping you can direct me to a substitute, if not the actual glazing. Thank you in advance for your help with this project. Andrew B.

No markings on Windows double hung top window

The metal portion of the channel balance is 23 inches long. The window is 25 inches tall X 51 inches wide.

Pictures of both old and new. New one doesn't stretch far enough to catch under the window clip. From the clip to the top of the bottom window is only 3". Most that I have done are 12" or higher. This window is only 28 lbs and 46" wide.

I have a channel balance with a broken sparing and need replacement for it. The channel is marked or stamped 1620 and is on an Alcoa Window. The aluminum channel is 15 inches long with nylon ends. It looks like the S350 with what I could tell from the Photograph. The House was built in 1980 with dou ... (cont.)

I need 2 balances. The old ones measure 28 x 5/8 x 1/2, there are no markings. It looks like your 351 unit with the 2740 option could work. The window weighs 23 1/2 pounds

Hi, I bought these single hung window from Home Depot about 15 years ago. The metal part of balance measures length 20.5" width 0.5", windows weights 14.5lbs. Stamp on balance 20 2(see photo). The winged shoe width I measured 1.09" so 385 should be correct.The closest I see from your web site is 385 ... (cont.)