Viewing all customer Discussions for:

Door & Window

Dear Swisco Staff:I need your assistance. I'm in need of a replacement door sweep for a Peachtree door. Attached are photos of the door which measures 32" wide. Most sincerely,Robert

I need 2 wheel assemblies for my patio doors

I am looking for brass window cranks for a home built in 1930 with a large number of leaded glass windows which I believe were by Getty of Philadelphia. Attached are pictures. The base of the crank is around 6/16 or 7/17 wide. Some of the groves are worn a bit thin so it will vary. ... (cont.)

Cant really see the number but thought maybe your experince would help looks like one is : U8 11L 12 87 and the other is o4 11R 12 87 Thanks, Jeff

I need replacement wheels for my screen door.

Channel balance from 1993-94 Kinco window, 29" long 1/2" wide. No names, numbers or markings on it.

This came from a very old window the only markings are the number 1820. I need two it measures 19 inches in length. 5/8 depth and 1/2 wide. The spring is 9 inches

Can you help identify a replacement latch for my Andersen Double Hung windows from 1980. The part number on the back is 1630008. The spring mechanism on the lower sash is below the surface of the sash. The upper sash rail has a slight angle to it that doesn't come through on the pic. I haven't h ... (cont.)

I need the unit #2345.32.212

The hinge is 10 cm long,Thickness of aluminum is 1.7 mm.The shaft inside is 13 cm long, with 4.5 mm external diameter.The Brass/copper flange has 6.7 mm external diameter. The lip on the end of the brass flange has 9.4 mm diameter.If you need other measurements, please let me know.As you can see, on ... (cont.)

Do you carry this type of crank? I need 3 of them.Thank you,Ray

Hello, this a drawing of the aluminum bead with it's measurements. It's really bent up so I didn't take a photo. Do you have a plastic bead that's similar or will work?

Please let me know if you have this Left handed jalousie window operator crank for old steel casement window?

This is likely an American Craftsman 500 series. The outer hole spacing is 3 7/8", the inner 1 1/2".

I live in Canada. Can't seem to find a Canadian dealer with this part. My crank works fine, but the lock "snapped" when I latched it THe following numbers apply: CCMC 9184 &11404 Brevet Can 1,160,, 103 Brevet USA #4,440 M90 A3,B3 C3, F2

The balances appear to be friction only units which lock into a channel. The pivits slide into a slot in the bottom

I have previously replaced the Balancer in a kitchen window and I have a handful of springs and string. Therefore, something has gone wrong. The window weighs 34# 51" Wide 32" High Balancer is 29" Long Please reply with the correct balancer and what might have happened

Part # 2573558

Have a coil I am trying to identify weight it has either a 6 or a 9, from the screw hole on top it's a 9, if I were to hold it with the tab pointing up.

I am needing 8 balances stamped 2020 and 2 balances stamped 1420. Also need 10 of the sash clips shown in the last pictures. Thank you, JR Morden