Viewing all customer Discussions for:

Door & Window

How do you remove the old disintegrated pivot bar on a patriot vinyl window? Will the one on you site work for my patriot window?

i need a pivot bar for a tilt out window. no markings on the window to tell what the manufacture is. the pivot bar is 3 1/4 inches long and is stamped 6247. attached are some images of a good one.

I need help locating the latch for this awning window. Can you help me out I attached some pictures. Please let me know if you can help. Thanks Steve B.

Window arm clip

Can you please identify this window pivot

Please check the measurements on Key Tumbler #40-089. I'm trying to replace a PADO tumbler...and it locks 2 times as I turn the key. The key is little...and the key is a MD10. These are my measurements of the PADO tumbler... Length...2 3/8 inches Height...1 inch Width...5/8 inch Thanks! #40-089 ... (cont.)

I am looking for the glazing which thickness is 0.02 inch. I find 0.03 inch one and it is available everywhere. The part code seems to be VGBFBTL. Can I get 0.02 inch one here? Thanks.

I am looking for a replacement of the pictured balance. I believe it is a Series 385 Sideload Channel Balance Sash Support System. It is 26" long (metal section). However, I am not sure about the bottom insert as mine is slightly different than that shown in your photo. I did not upload a photo, ... (cont.)

Would like to replace a pair of channel balances for a Viking non-tilt window. The length is 29 inch, the marking says 2840, then BF, but I can't tell the correct series number to order.

Looking for a replacement for an Amerock 2110-2 7/16" overlay 06U hinge. Do you have one? Thanks, -Bill

Window uses 2350 balance. Bottom shoe dimensions are approx. same as part 15-004, however between and below the wings it has a small pulley which the cord goes around and the shoe also acts as a stop for the clip. Picture attached. Do you have a shoe like that? TIA...

Need 8

I have drawn a detailed 3-d representation of my window glazing. Please let me know if you have something that will work for my windows. I think I will need about twenty-five to thirty 6' pieces.Thank YouRobert

I need to replace two S385 22? balances. However, current balance has an old number format. Can you help me Identify the correct option. The number stamped on it is: 21 2 B.S.I. 0E Thank you for your assistance, Rob

Size is 1" wide x 2-1/8" Tall x 9/16" thick What is the correct replacement?

Hi: so I removed one of my bad spiral window balances. there is only one "hook" on the end of the spiral (see pic). And there is NO color code. Diameter is 5/8 and length is 25" I THINK your s600 -25 will work... should I just determine the "color code" by weight? Do you think this will w ... (cont.)

I have 20 year old Mercer vinyl windows that one of the spring lifts cords broke. Images are attached. Total length is 28 inches. The markings are in the third image provided.

Need a little help here. I think the Sash replacement part number part number is 29 inch S351-29. And I also need to replace the top sash guide j

Marking is 25 4 BSI PK Length: 25.75" metal only tip to tip. so is that 26" or 25"? Width 1/2" Shoe seems to be 1 3/32" so seems like 385 ? Seems like I need the 385-25 or 384-26 with the 2440 weight option?? Let me know. Thanks!

EE 6 31 18