Viewing all customer Discussions for:

Door & Window

Can't open the window because the inner part of knob are gone.

Looking for a lock for a sun sliding wood door

The window opens and closes but when shut completely the window won?t open. I am looking for the right encasement for this jeld-wen window.

Hello, Trying to identify this part. Number on the operator is C-1040-9A Number on the arm is F-1040-67 It looks JUST like this item of yours, I think mines slightly bigger :( https://www.swisco.com/LH-Split-Arm-Operator/pd/Casement-Window-Replacement-Operators/39-317 I don't need the exact part ... (cont.)

Hi. Im looking for this balancer. It mounts in sash of tilt window. and it has pivot shoe on the balancer. please help me to find it

Channel balance for Milgard window. Number printed on part is 26 3 LV CMC 1Can you tell from this information what item I need as a replacement?The length Of the metal is 27 inches.

I need the door lock and key for this simonton sliding patio door.

Latch for tilt window.

The numbers and letters are 26 5 DW CMC 4

Any assistance on this part to purchase would be greatly appreciated. I believe the windows were manufactured by Atrium?

Is there any we?re i can find this component in Omaha ne or a good replacement

this is a rivet for a storm window channel. please advise

Hi, the balancer I?m trying to replace is 27in, shoe 1-1/16, and the sash weighs 15lbs, but I don?t seem to have a code. Can you tell me which balancer I need please? Thank you!

This window glazing seems to be 1/2" x 1/2" x 1/2" please confirm which item number on your site it says thank you very much for your time

thanks and finally i need this piece that attached to the other end of the spring.i think this is the right mounting bracket.https://www.swisco.com/Mounting-Bracket/pd/Sash-Support-Coil-Balance-Accessories/16-024

Hi,Two of my window balances are broken and need replacement. I have attached photos of stamp and plastic shoe on both ends.When i measured the metal part (not including the plastic shoe part on both ends) they measured as :- part that says 25-9 KX CMC 7: metal part is 26"- part that says 26-9 BA CM ... (cont.)

Want crank identity so I can order 2

Where do I buy tension ballast tool for aluminum windows? Where do I buy new ballast covers for aluminum window?

looking for a viking window balance numbers 2640 bsi not sure on which one i have since the lenth measures 26 3/4" x1/2" looking to order 4 as the clips has torn threw the plastic on the ends one of the pictures has the numbers on it. any info on the model would be helpful thanks jim ... (cont.)

I think my casement windows are Visions 3000. The part of the tie bar guide that holds the tie bar broke. The width of the guide is 3/4". There are two holes on each "wing," and each wing has a single white peg. The width of the guide at the bottom of the wings is 2".