Viewing all customer Discussions for:

Door & Window

r/h awning window operator 5-1/4" between holes. 1 hole at top 2 at bottom 1-1/4" between them 2-1/2" between connector rivet and bushing on arm. prefer white operator, but will take other color. do not know brand of window. approximately 20 years old. please let me know asap if you have a matching ... (cont.)

We have old Hope operators in a 1950's house. The arm measurement is 9.5" rather than 9", measured as you show in the diagram. Will yours work OK on our windows (i.e., just shorter swing-out)? The crank on ours is not centered on the base, but offset a bit. Is that also OK? The 4-1/8" screw mou ... (cont.)

Looks like I have a broken Jordan window balance and what I believe what you call an end cap on the same non-tilt window. Need to ID correct replacement parts that need to be ordered. Pictures attached. Do the replacement balances come complete with the plastic pieces at the top and bottom of the ba ... (cont.)

Hi, need keeper for simonton sliding glass door, part that goes on jamb.

Our windows have cracked and broken spring covers on the sides of the casements. Some have broken, fallen into the bottom, and caused the windows not to open. Please advise if you have equivalent replacement options. I have enclosed a picture of the Simonton tag. I am unable to remove the part. ... (cont.)

We are searching for replacement window parts for Reynolds Windows. Attached are photos.

Hello- I need to replace this part in several windows. I am not sure which is the most suitable part to use- there aren't any on your website that are exact replicas. My best guess as to measurements for this part are: 2 inches tall, 1-1/2 to 1 5/8 wide, and 9/16 inch deep. Which part do you recomme ... (cont.)

hello, I was wondering if you have #84-021 style in metal wheels Thanks, Paul

I am missing the operator handle for an Eagle window. It appears to be 5/16 " . I thought I should check with you to be sure which Anderson part will suffice since it is an older window.

We recently purchased your 27" series 900 spiral balances for windows. We need 1 of the white plastic pieces shown in the picture but for the left side. Please advise.

Looking for replacements. What causes the screw handle to come out of the socket when closing?

I need to replace the balances in my window, can you tell from the pictures which I need to order?

have a Cole Sewell storm door and the handle is shot. Cannot find the replacement for it. Reg. number on door is 102695947360016 but don't think that will help. Total length is 9 1/2 inches. Hope you can steer me in the right direction. Thanks

the stamping for the weight on my original balance does not match your numbers. My balance is stamped 29 9 LW CMC 7. what is the equivalent in your numbers? Thanks!

Looking for kinro window vinyl

Hi, do you have replacement arts for this roller assembly? Thanks David

Depth is 0.5 in, width 1.25 in, high 3.5 in

Hi, I am 100% convinced that I need the following part 15-046, i've measured the window frame, broken parts etc. On the photos I've attached (IMG-1454) you may notice there is another plastic part which is clipped to the front of the 15-046. I can't be totally sure that this part isn't also damage ... (cont.)

The window does not crank open as the rod with the plastic ball on the end continually pops out of the track on the window Wondering which replacement part we need? Thanks!

This is for a non-tilt window. The metal piece is 27" long by 5/8" wide. The stamp on the balance is The stamp on the balance is: 26 4 j cmc 11.