Viewing all customer Discussions for:

Door & Window

Handle needs replacing

I'm looking to replace this handle on attached please let me no if you can help with this?

These are broken in 3/4 locations on 2 windows. The pics are from the same windows in a different room. I need to repair the 2 windows. Thank you for your help.

I have an Anderson casement window, I think it's built around 1996 or 1997 as one of the arm indicates. I need to replace the operator. (See attached picture.) The part numbers are these: Front top: C-9400-1 Back top: C-9400-8 Arm: 2 361399, (or could be 2 1361399 as the F

My guess is a 3/8 series 301 15-011 (based on shoe shape) No names, numbers, or markings found. single hung non-tilt. Length is 22 1/2 inches? see photos Thanks for your help Gary

Hello, I need two new balance coils for a Capital Windows Series 8500 window. They both seem to have snapped. Unfortunately there are no stamped numbers on the coil. I asked my tenant to measure the window and she says it is 23x24 (it is a single hung bathroom window). With the pictures I s ... (cont.)

this part is what hold window open

We need 8 tilt channel balances. The number stamped on the side is 27200H. 29". Please see pictures. Thank you.

Hello, We have a Pella out swinging screen door that was purchased and installed in the 80's. The handle/latch mechanism broke and we have been unable to find something that will work. Will this work on our door?

Greetings, I think my doors are in need of this part. I was wondering if the bearing itself is replaceable, or does the assembly need to be changed out?

It is only two inches long and cannot seem to find them anywhere

parts that i am looking for Thamks

I ordered these...they just arrived...no screws are included...do you sell the screws?

I can't seem to find the right size. The ones shown in the package are similar, but I doubt they will hold up. Mine are nearly twice as wide as the ones in the package. Thank you, Anthony

When my home was built in 1978 or 79 a Pella sliding glass door was installed leading to the deck. The door is wooden construction but has no metal cladding. After careful inspection I have been unable to find a model or serial number on the door. One of the roller assemblies has failed making the d ... (cont.)

This is the seal next to the bottom rollers along the entire width of the door.

I need the lock mechanism, appr 4 inch x 1 5/8 inch x 1/2 inch thick

Due to hail damage I need what the window and exterior door sales person at GBS in Mauldin, SC called a stop and is the person recommending I contact you. I have a 14 year old glass sliding patio door made by HURD Millwork Co. Inc Series: VSLPD, CPD HUR-N-052. Per the sales person at GBS HURD was s ... (cont.)

I need locks and springs. The spring holds the lock down in place against the window frame by the spring pushing up on the slide up window lip / grab rail. The window lock has two bulbs ends which slides into a track underneath the grab rail and there are two notches on each end of the lock that h ... (cont.)

Do you have anything to replace this