Viewing all customer Discussions for:

Door & Window

Milgard Windows - 25 5 IV CMC 0

I have the sgd-r20-96x96 sliding glass doors. Which rollers fit this sliding glass door? I need 2 in the door on the bottom. And I'd like 2 for spares also. Thanks, Daniel

Hi, I have a Champion window[company out of business] and need to replace the string and bar parts on 1 window. I ordered the 27-4 balance system which is the replacement part. How do I install it? Do I need to have a repair man do it? What do I tell them needs to be done because not everyone kno ... (cont.)

Picture 3423 is of window identifying label Picture 3428 is of broken piece, tilt pin that needs to be replaced Picture 3429 is of unbroken piece Picture 3430 is where the broken tilt pin needs to fit into I think tilt pin would be about 3 inches?? Can you recommend a replacment part. Th ... (cont.)

TRUTH RH 45136 US PAT 4505601 PAT CANADA 1986 UK PAT.2135397 please help find part i am struggling to locate it. it may be maxim? but i can't confirm William

Locking slide mechanism on top of stationary door I need to put one on the bottom of it to make it more secure

Hi I have 6 double hung windows in need of new hardware, Pivot shoes and pivot bars. My math tells me that I need 24 pieces of each and if I purchase 25 of each I'm farther ahead and I will then have a spare of each. I also need a spiral balance charging tool. I think I need the 15-047 pivot shoe an ... (cont.)

Looking for replacement rollers for jeld-wen screen door in the picture....door was new in 2007

I have just purchased a home that has Jeld Win patio door. I want to see if there is a way for me to replace a normal patio door handle to a keyed patio door handle.

I didn't get any numbers off the window. Just a good picture of where the crank attaches. Thanks!

Hello, There are like 6 of these clips, per screen panel. They are broken. They hold the screen in place on my bay window. I need replacement parts.

I need to replace a pair of sash balancers on a window. The numbers on the balancer are 11600R-2 and 837K24 04 06. Would that make it a part number 837? Thanks Paul

hello we are looking for replacement parts that hold up the window on either siode as shown in the pictures. I think originally it has spring mechanism but AI cant be sure. i hope you have such parts. thank you

Hello, My 1979 house has Alcoa aluminum windows that do not tilt, they just go up and down (but only the bottom half). I'd like to replace all of the balance spring sets (plus the handles, locks, gasket and the little stopper tabs at the top!), but I don't have a clue of what the part numbers wo ... (cont.)

No markings or numbers. coil is broken on one side, window will not stay open. Can't find parts anywhere. 1.25 inches high by 1.50 wide. We purchased parts for our screen door handle thru you and were very satisfied.

I was hoping you could identify the proper channel balance. They're 1/2" wide, 16" long, 1540 series (please see attatchments below):

I require a similar piece of vinyl but with a flatter angle than 55-197. More like 55-164, but with more of a square slot where it clips into the frame. My original piece seems perfect, but some areas are tight yet falls out at some points in the door frame. I'm wondering if 55-197 would snap in ... (cont.)

Non tilt. 1540 60 series listed on ejc catalog

no covers on windows.measurement of hole is (1.5)x(.125).need 24 covers