Viewing all customer Discussions for:

Door & Window

The markings are: 29 3 FQ Caldwell. The length is 30".

Looking to replace two of these rollers. Has a metal housing with a nylon roller and a nylon gear type adjuster shown here broken away from the top opening.

I would need 4

Hi, I'm trying to buy some window balance channels but I'm not sure which type should I order. I'm attaching some pictures. Would you please help me to identify what type of balance is and how much will it cost to buy 2 units? I live in California. Thanks, Luis K

need replacement balances for a window from Republic Windows that is out of business. Photos are attached. The balance is stamped 26G. Photos are attached. The balances have been replaced before. The window is 45 inches wide, 29 inches high and weighs 31.5 lbs. The is 27 inches above the window. ... (cont.)

The number 2330 and what seems like a partial "5" seems to be stamped on the front bottom. The metal balance is 24" in length and 9/16" width. The plastic clip on the top is 1.25" The total length from bottom plastic to top plastic is 25 9/16"

I have windows that were manufactured by a company no longer in business and need to replace the window glaze on one of my windows. Please help me find the best match. Thanks, David

I hae a Anderson patio door which was installed in 1989 and the door is very hard sliding I have adjusted the ollers at the bottom of the door using screwdriver into plastic roller adjusters doesn't seem to lift door enough

Hi the number stamped on is 32461

Hi Do you sell a screen corner like the one in the picture I attached.

The ribbed channel of our current balance is 32 1/2" L x 1/2" W x 5/8" D. Looks like your s751 balance but window is non tilt. Window is essentially a room divider that can be opened from either side.

I am in need of 3 pair. Please let me know if you need anymore information from me.

I send you the picture number ref 7501320 PAT 5410778

Single hung unit the tilt out block still holds the window but does not lock in the track as it has broken off. spring is coiled up under the white part that is screwed to the sash. Thanks

Are you familiar with these pivot bars & pivot carrier block ?

Need a new replacement handle for sliding door. Can you help please? All it says on it is dns ind.

Part #1720 (BS1, Z, I) Part #1420 (BS1, Z, I)

need replacement parts both balance springs busted. Shoe is 1 1[4 wide and 1/2 deep and 1 3/8 high. Spring is 1/2 wide. pivot pih is 3" long with holes 1" and 1 7/8 inch from end. only one screw used. sash is 13# and is 32 3/4 by 21 3/4 inches. What assembly do you recommend?

Looking to replace the part for an Arcor double-hung window. First picture is part that works. The 2nd and 3rd are the broken part! Thanks for your help! Christine

The part on the side of window jam that slide up and down and holds balance spring.