Viewing all customer Discussions for:

Door & Window

can you please identify the attached hardware?

Could you tell me what the correct replacement is for my "Air-Tite" Pivot Shoes? I measured the thickness at 3/4" and attached are a couple of Pictures. Do you need more Information or Dimensions than this? Thank you!

Hi there, we bought an early 1980's era mobile home with old storm doors and the slide bolt tabs for the bottom of the removable windows are broken off. We cannot latch the windows in place at the bottom, nor slide the windows up to catch on the different heights for ventilation, have to remove the ... (cont.)

I looked through your website but was unable to find my hardware from the pictures. My patio door is about 20 years old. The opening in the metal door is 1" x 7.25". The opening is cut through both sides of the door and is located 5/8" from the edge of the door. I have attached several picture ... (cont.)

24" long 1/2-9/16" wide 5/8" deep 23 B stamped on them

my registration number for my Pella door is 082002psd3037cal 0300. can you tell me which door sweep replacement product would for that door model. thank you so much.

A large number of my pivot shoes are stuck at the bottom of the track and do not function. Most of the time when I try to pry them loose with a screwdriver, they break. If they don't break, and I try to use them again, they get stuck again. I am looking for suitable replacements. Hopefully a differe ... (cont.)

I am having trouble finding a replacement handle. The holes are 5" apart. Attached us a pic of all the parts Can you help with any of your products?

The existing spring has the following numbers: 25 - 3 BH5 CMC 75 Are you able to identify and/or provide replacements? Regards, Chris

After looking at this part (82-107), I think it is what I need but want to confirm. We have a Pella door that is over 10 years old and 1 5/8" thick.The lever pin broke, but we are able to retrieve the entire piece from the door. Will this work? Please advise. Thank you.

I'm looking for a sash lock similar to 90-077A but without the alignment lugs.

29" long X 9/16

Hi there, Attached is the part we need to replace. We would like to order the channel balance, but are unsure of which series/top/and shoe order is appropriate. We will need this shipped to Vancouver, BC. Please advise and confirm if shipping to Vancouver is possible, thanks for your help! ... (cont.)

These balancers are from 2 different windows. Both are tilt windows and the balancers are 1/2" wide. They both have the same ends as pictured. So, I need 2 of the C2745s, and 2 of the C3920 (52)s. Please let me know if you have further questions. Thanks, Jimmy

Need some mounting hardware as a few pins are missing and some exist but seem to have nothing holding them in place. The tracks appear to be in good order.

I am in need of the gear box for the Win-dor casement window hardware as shown in the images.

Can you please let me know the right sash channel balance to purchase? Thanks

I have 2 handles I would like to replace....... Lasted 18+ years.... Home Depot, Lowes and or Ace does not carry the correct size.....lock latch to in different location and door would not modification for them to work......Do you have the handles in stock and what would be the cost / shipping fee?. ... (cont.)

If I can provide you with the Serial Number of my Pella (r) One Touch (r) Storm Door, can you let me know if you have a mortise unit for it? I believe the mortise unit is worn out as the latch bolt will not spring out with sufficient tension such that the latch bolt secures the door closed. Or do yo ... (cont.)