Viewing all customer Discussions for:

Door & Window

Can you get me the part under the spiral? Thank You, ED

I have patriot Windows with a spiral balance length of 28.25 inches, should I order your 28" length balance as a replacement? Mike

Thanks for your help! I have Alcoa single hung windows that have problem spiral balances, either locked up after 6 in of travel or making noise when closing the window. I have included two pictures of the balance. It is 29" long (plastic only) and I believe has a yellow color identifier (in pic ... (cont.)

Hey guys...am trying to include images of the door "handle lever" that is only 5/8" in length...way too short...I need longer by at least 3/8"(I think) Thanks, Bert

Need to replace lock. Marking on lock set 8115 N.A 8120 N.A 8117 N.A

Searching for 06090711036. I am looking for this part for my door. The door is a Pella. Thank you

I need some assistance with my stanley rolling door top wheel. I have 2 photos attached and wondered if you could help me at all with this?

I'm looking for replacement weather stripping for this door as well some way to bridge the large gap between the two doors. the gap is close to 3/4" wide. Thank you Roger

I have a peach tree sliding screen door and I have a broken strike. Would this work for a replacement part? Or do you carry something that will work?

I'm not sure my current parts are Swisco. Does it matter? I hope you can help me identify the correct replacement parts. The metal part of the channel balance is 27 1/8 inch long, not including the plastic top or shoe. It is 1/2" wide. Printed markings say "26 4 CALDWELL HM"

Need to replace spiral windowl tilt balancer L=28" dia :28" black , pivot lock shoe L2" W 15/16 T 9/16 ( which should fit the better bilt die cast pivot bar 85-698 ) Please advice me. Tnx

Hi Trying to replace the channel balances on this window. It's a Viking window. I've measured the metal part of the channel and it's 29 7/8". Looking at your website, my channel appears to be a S395, but can you confirm? The window sash weighs 19 pounds. The only writing on the channel is "29 4 E ... (cont.)

I need to replace both the right and left sash balances on an Andersen Narroline 3042 double hung window. What is the correct Swisco replacement part for each of these balances? Thank you!

My wheel is 1-1/4" in diameter. Do you have this roller?

I am inquiring to see if you carry these parts on your website? If so, I need about 20 pieces. Thank you, Rick

Hello, my windows use a 2740 S385-28. They are extremely difficult to close down--I have to hang on them! I am going to switch to the same PN but 2730 (sash weighs 19lbs exactly). However, several of my window sashes seems to move at the top (side to side) enough that when I install the sash and ... (cont.)

I need to replace several channel balances for single hung windows with the following numbers 29 5 CX CMC 11. I need to know if you carry this item and if so order the parts. attached are pictures of the channel balance. The dimensions of the metal are L 30

Diameter = 1" / 25mm thick = 7mm axle Diameter = 5mm pin on ends of axle = ~3.5mm plastic with metal axle I believe that this is a RiteScreen 140SMFIT30BN from ritescreen: JI2704ZY does this roller have the dimensions I supplied? thanks

Can you identify this window shoe?

Awning window/center mount...says truth on arms...(40011 and 40012) Cranks are stripped... Need 5 new ones... Suggestions?