Viewing all customer Discussions for:

Door & Window

Do you guys sell window springs? See attached pictures.

Looking for nylon washer that goes between the door handle and door on a Milgard french door model HGD-C30-96x96. See pics attached. Outside diameter is 7/8, inside diameter 23/32. Thanks!!

Good morning, I'm trying to find the missing opener for this window. It's been missing since we bought the house a couple of years ago. The only markings on the window is white markings, on each pane, that say ECO1429

Part is hooked to spring balance

Need to know what part to replace older truth window tie bar guides. I tried to give closest measurements needed. Basically 1in holes 1in from holes to clip end

We need a new crank assembly, but don't know what part or parts are required. We have attached photos. The only numbers we can find on it are L30841, the gear has 30843L and the long straight part says 20810. It has made in USA also and the brand looks to be Trust. It also has the patent numbers on ... (cont.)

I'm looking for Tilt-Latch for Crystal Windows. Here are 2 photos, 1 is the whole latch, the other is the latch with the lock broken

Hi,Please review and advise if you carry the attached.Thank youLuanne

Swissco,Please help me find a solution to my broken latches.Please confirm 91-010 is my closest option.https://www.swisco.com/Right-Hand-Slide/pd/Panel-Replacement-Latches_Springs/91-010Regards,Mike

Shoe for window

Trying to repair old aluminum slider in mid century home. Windows have come apart at corners that held slider together

I have looked all over and I really dont think these are available anymore so if they are not is there an alternate that can be used. Thank you for any information you can give me.

The part in the window frame that accepts the pin in the corner bottom of window is broken. Also the pin that screws into the window broke out of the window (has two screws).

Hello, I am looking for replacement Balancers for Double Hung Vinyl windows. The part is stamped 25TG and it is a little ober 26 inches long. I found the part on your web site, but the connection is different, as you can see in the picture it is a small square. Can you direct me to the correct pa ... (cont.)

I have croft windows and Im looking for snap in glaze I have a piece.

Channel length - 23 5/8" Channel width - 9/16" Channel height - 5/8" Milgard window 18 years old number on channel is 23 3 I'm looking for 10 channels

I don't know the depth of the pin that inserts since I dont have the broken ones. Is there a way to pop one out to measure it?

I have 4 windows that have the 2970, 2 windows with the 2330 and 2 windows with the 3365

I am looking for 1 right and 1 left operator & I also need 2 inside left folding handles and covers & 6 inside right folding handles & covers all with brushed nickel finish. They are for milgard 3510 casement windows.

I need to replace 2 channel balance on my sliding window. ( house build by Lennar ) marking are : 30-11 H05 CMC 3 lenght of the metal channel is 31inch width 1/2 inch