Viewing all customer Discussions for:

Door & Window

Pivot shoe not functional

Just need the thumb sliding part. The Mechanism works. I just ned the piece that you move to unlock the mechanism.

Looking for replacement operator and handle in white

Overall height of 9.5 inches, with screw holes 4 inches apart. Color is dark bronze.

Had a screen malfuction. This was in the screen frame for a tilt/turn window. I see a K/K in the corner and a 3 on the one leg that is not broken. From the leg still in tact, the dimensions via caliper are 0.67 inches on the U shape, if I include the back it measures 0.78 inches, the corner is 0. ... (cont.)

i need three uppers and one lower handle of this type.

Need help with selecting the correct replacement guide loop that attaches to the truth 30752 operator, (or selecting a new kit) and also need new folding handles

I have this Truth piece with the number 31850 on it and the crank that says Weather Shield on it. I really need just a crank that can be stored flat after using because of new blinds purchased for this window, but the window doesn't close very easily, so I'm fine replacing that too. What do you sell ... (cont.)

Label on handle says Classic Mayfair. Screws seem to be 4" apart.

It holds the screen in place opposite of the screen lock, pivots on the screws to allow screen to be opened

I need 2 of the above balancersThank youSteve

Need to identify and purchase two single rollers for my sliding glass door. The dimensions and diameter of the wheel is 2 3/8' L x 1 3/16' high and 9/16" Wide as shown on uploaded picture with a 1 1/8" wheel diameter. PLease advise.

These part is what holds the window to the spring. Please I been searching for a long time.

1/2 inch wide 34 inches.

Hi, these came off the bottom of a sliding glass door. They're bent and need to be replaced but I'm having trouble finding a replacement. A lot of the replacements that are the correct measurements have open tops, but I need a closed top with screw holes due to how it mounts to the bracket under the ... (cont.)

Need 2 of each of the channel balancers stamped 1520 and 2320. The length of the metal channels are 15 7/8 and 23 7/8 respectively. Pics attached.

The key for our slider vanished. I'm not sure which is the easier, faster solution. Do I need to replace the entire handle/latch assembly, or just the lock itself?

hi there looking for the most compatible replacement for this. Thank you I am sorry I don't have the removal photos.

Hi. I have never seen these or know what to even call them.