Viewing all customer Discussions for:

Door & Window

Hi, I need 3 set (2 for each set) of new 1/2" non-tilt channel balances. See attached photos, first set is labeled "26 4 JV CMC 2", 2nd set is labeled "26 5 IV CMC 8" and 3rd set is labeled "32 5 IV CMC 2". Please let me know the correct part number from Swisco. Thanks.

for double hung window in a college

it is necessary to replace the rusty part because the guide in the corner of the window broke into the window and does not lock tightly in the closed position

Broken left latch

Looks like someone broke off the latch. I need a replacement or something else that uses similar hardware.

30" long 1/2 channel

Hi, I need help finding the right window parts to switch out with current ones. I'm looking to replace with a different finish.

I do not recognize this tip on this style balance rod, can you help identify for a replacement

The crank only opens the window an inch, then it "wheels" into emptiness as if it wasn't latching onto the mechanism. truth hardware anderberg mfg

We are in need of 2 sets of these cranks. We have not been able to identify what brand of windows that we have. please let us know if you have the correct parts.

I need metal screen door clips with short screws and flat clips for picture window. Both date from the 70s if that helps.

I found these on a seperate site as F4040 but there's no option to buy. Through a discussion board I found a roller on your site that is said to be a replacement, but they don't look the same. Could you help me identify the right parts? I would need 2 of them.

1/2" width 30" long Only identifable numbers are 29 4 BSI Out of frame, with spirng in resting position, spring is approximately 18.5" long Windows are non-tilt, roughy 33.5" x 33.5" square

Looking for exact replacement for window balance. One side string broke so just looking to replace both. 2630 is stamped but that's it. See photos attached

Is this part even replacable?

product code: 90-180 but in almond. Any chance of finding one of those?

Attached photos of a channel balance from a probably 2005-ish Pella window that I need to replace. It's from what I think is a non-tilting (don't see any tilt latches) single sash window and is 1/2 inch wide and the metal part is 16 inches long. I went through your Part Indentifier Wizard and it l ... (cont.)

Hello, I am replacing my clips and window balances for my single-hung window. I just wanted to ensure I was getting the correct parts before I purchased it. I have attached pictures of my clips and balance. I think the replacement part for my window balance is part number S351 and the top clip is P ... (cont.)

Number identification as per attached photo. 610,108 I would like to order 2 sets for lower sash

Good afternoon, I need to buy 2 new window sash Balances. I've uploaded 5 photos. Let me know if you need any other information. thank you