Viewing all customer Discussions for:

Door & Window

I am lookin for this part. I did not see kit in your array of door spring rollers.

I need two replacement pivot bars for the top sash of my vinyl replacement window. One pivot bar broke at the neck and the other had begun backing out, so I want to replace both. The window was manufactured in December 2018. The removed pivot bar is approximately 2½ inches long with two mount ... (cont.)

Small bathroom window sash brake for tilt window pivot

Need parts

Looks like the Certainteed shoe...not sure. Measure same. I

The part I'm looking for is a Windows balancer there's no descriptions or part numbers listed on the actual hardware I could describe how large or what size is it? It's approximately 29 inches. We have two plastic connections one on top and one on bottom and the springs are in the middle and there i ... (cont.)

Double hung window hook end broke off

I need roller assemblies and top wheel assemblies please

Bottom hardware for Eagle windows the stomp on the window is IGCC CBA IGMAC CIG-3 2-99

roller assembly from sliding door

These are from 1960's era aluminum windows. outer screws are 4 5/8" center to center The arm is 9" from center of pivot to center of disk

Good morning, Do you carry this kind of Trigger Pull Handels for storm door? Thank you

We purchased 2 closers from Swisco, item # 79-253. They were perfect replacements for our original door closers. We made the adjustments for controlling the closing of the doors. However they are very hard to open, from either side of the door, pulling or pushing open. I feel sure there is an adjust ... (cont.)

It's a window crank. Inside the crank there is a number 45054

The attached pictures are of similar window crank mechanisms. The actual.broken cranks are on upstairs windows, making opening and closing a death defying feat. So, we took pictures of other window cranks that are the same as the broken ones. We need left and right cranks. We also noticed that in so ... (cont.)

Hi, I hope you have the replacement part. If you do, I would take two sets, one for the right and left in a set.Thank you so much, Carol Deming

My window tilts forward and goes up and down. I need a replacement latch piece for it. A contractor took these off and replaced it but the window cannot slide up and down with this replacement. It only can tilt forward.These are the original ones that were in the window. I need one that is either th ... (cont.)

Need replacement parts for double hung window. Also, instructions on how to replace. What additional information is needed?

I need to replace this.

Hi! Just need a crank arm. I took pictures hoping they would give you enough information to help meMine also said entry hard on the mechanism and Semco on the crank handle