Viewing all customer Discussions for:

Door & Window

Hi, My name is Meng and I this spring to fix my windows. Please let me know if it is available. Please see the attached image. Thank you

I think the item in the photo is call a window pivot shoe, not 100% sure. I have two windows where the pivot shoe is broken on both sides.

I'm trying to identify this pin on some old windows I have, while I save to replace them. They're aluminum windows and this current piece is metal. The pins are pulled back to raise the glass, and sit in divots that are built into the slide rails, to hold the glass up.

This is on the sliding door that is stationary. One on top and bottom this is the top one.

looking for part number -30818

Older Screen door handles and lock set marked 9976 and 9977 on handles

Does anyone know the part number to radiance pivot shoes that have coil tension that clips on the back of the pivot shot not sure of the pivot shoe size

Please help identify Vinyl Glazing Bead, thanks

I am looking for a support arm for this Jeld when window. It has broken due to rust. It is approximately 7 inches long.

The stamp appears to read 28B with BSI or BS1 below, then a sideways E on the third row of lettering. It has a plastic "C" shaped piece attached to a synthetic (nylon?) string that goes up into the metal piece. Only a screw at the top holds this up and I was unable to success remove this from its or ... (cont.)

the handle is loose, can't open and close

Need help identifying this pivot shoe.

The latch to my sliding glass door no longer hooks into the catch. In fact when the door is open the latch will not extend out from the door. I believe this is a Swisco product but not certain.

I am in need of one of these. I have no number. The cabinet was purchased at Lowe's

Sliding Door Latch Lever Kit Product Code: 82-107 does this lever come in Dark Bronze. See attached Pictures

These are for a homeowner I am working with. They say they are Pella Windows, but I am not certain looking from the outside. They are awning windows with a crank only on the right hand side and lever mount locks. I may need to peel back the trim before knowing the right pieces but I thought I'd gi ... (cont.)

Hi, please see attached picture and help me identify the correct part number. There is no stamp information on the old parts. The width is a little more than half an inch. The length for the metal portion is 27 inches. Thank you!

The number 1720 is on the channel balance. The width is 1/2 inch. The length is 18 inches. I do not see a clip in the channel, but I know this condo was built in 1982 in South Florida and these are the original windows. So, the clip is probably broken as there is no support on the right side and ver ... (cont.)

The worm gear came out of its pocket. If I have the worm gear facing me the long arm on the left side of the base has engraving that says Entry Gard and then TRUTH. The mounting base of this crank has a recessed area at the top with a number of 45179. There is a shorter arm that comes off of the sam ... (cont.)

Do you carry thos item ? Tried to get line unstuck from pully but not budging.