Viewing all customer Discussions for:

Door & Window

Hello! I'm reaching out for assistance with replacing the crank handle for one of our windows. The current crank handle (please see the attached image) needs a full replacement, and the neighboring window is missing this part entirely. Could you help identify the correct part(s) and advise on ho ... (cont.)

There are no numbers on this part

Hi, I'm looking for a Specific window balance I want to make sure that they fit The numbers are hard to read, but it is 26 4 EN Caldwell

30 7/8" from end to end, spring is 15 1/4" end to end, 9/16" wide, looks a little bit over 1/2" deep. Only text on it reads DB G02 30 REG, came from a WeatherShield window

Hi there - I'm looking for some replacement keepers from Roto that fit our euro doors and windows. We have some that have broken off (probably need adjustment). They are about 3.8cm long -- almost 4.4cm long or about 1.75". Thanks so much -

Hi there, I don't know where the thin strip of metal that fell out when I removed my door handle to tighten it.

I need a Block Spring and Tackle Balance Assy. Original Markings: 25-5 LH5 CMC 34 Metal measurement= 26" 5/8" Block

I need corner brackets for Mil Guard screen windows. They were installed in 2003. Hope to find some brackets that will last another 21 years?. Thanks

I am a home owner which also have some experience in window and siding installation. Need a piece of vinyl you window glass retainer. like the sketch sent. Hope you can help, thanks

Hello, I'm hoping your company sells a replacement for a 2002 Anderson Silverline Top Tilt Latch. Photos and dimensions are below: 2 3/8 - Length 5/8 - Width 3/8 - Height

Thank you.

I'm looking for the upper and lower hinges right and left side for this store

Hi, I have several broken sash pivot pins on my 25 year old Hancock windows. Can you check to see if you sell these replacement parts. Thank you

The rope snapped on both sides. Need the assembly. Thank you

.the distance between the right screw hole and the left one is 2 and one quarter inches (center to center)...

Spline inserts are 5/16" thick x 1/2" wide. Corner including flange is 1 1/8" x 1 1/8" square.

where can i find replacement window latch for trustgard windows

I am looking for replacement for this photo. Says part HGO4 2007U

I am looking for 2 of these channels along with the part that connects to the window and grabs this channel. Channel number is 26-4 FR5 CMC 34. I don't have a part number for the other part/. Thank you in advance for your help.Rich

We broke 2 of these, from 2 different windows. Not sure which ones to buy