Viewing all customer Discussions for:

Door & Window

Looking at Your website and I believe that I need S395-35 option3440. Can you confirm?

Hi, I want a replacement for this part instead of replacing the whole handle.

Afraid to remove and damage vinyl

I'm looking for parts to an old screen door. The house was built in the late 50's. I have the frame but need top and bottom rollers.

I recently ordered what I thought was the correct replacement pivot shoe for my tilt in Simonton window. I was way off. I've mailed my return and would like to place an order if you can identify the part from the pictures I sent you. Thank you!

Trying to find the make and model for this lock the internal gear broke at some point. Bar code is what's on the door. Leads to dead ends every time.

The lock and keeper are from a window whose only identifying marks are 226 62 ax. No brand name is apparent The screw holes are about 2 inches apart and the lock itself is 3 and 13/16th wide. The only markings on the underside of the lock are 5456 119. Thank you!

Do you have these?

I have a Pella French Door. The door seals, (sweeps?) need replacement. I bought some from you in Dec. 2015. They are 36 inches long and 1 3/4 wide. The rubber sweeps are about 1/2 inch deep. See photos Do you have 2 of these?

I have some swing out windows, the pivot pin broke, I cannot find any manufacturer information in the window frame. A local store suggested you, and said if anybody would have them it would be you.

Hello, I am in need of this plastic clip for a Certainteed casement window's tandem lock bar that goes up and down on the frame. Just need 1 and want to see if you offer it. Please let me know. thanks! Jason

I need several housings for the knife latch for the sash of 1938 Anderson casement windows. Housing length 1.5 inches, depth 5/16", opening 1.0. Material metal. See 3 pictures.

I need to replace the plastic bracket that holds the shoe. A bunch of them have snapped in the windows around my house. The springs are all present and in good shape as far as I can tell.

There is no name brand on the windows. The shoe is attached to a spring coil secured by a small screw. Dimensions are as follows: 1.75" L x 1.5" W x 3/8" D (dimensions are approximate)

29" circular balancer from old aluminum window

I need 8 shoes and 2 clips 2 3/8 long 7/16 wide 17/32 high or 7/8 high point The Brocken piece on the left has a hook to it to hold spring

2030 K

I have a couple of vertically sliding windows (each is a single sash). One of those does not stay up. The only label I could find says MFGR: AAP-011-3 Series: 3700/3750 From the above, I couldn't figure the manufacturer. I am trying to know what part do I need to fix it. Most likely, there ... (cont.)

Wheels are 1.5" in diameter Top metal portion is 3 1/16" Width where screws are is 11/16"

Need right and left side. Basic measurement is 2 5/8 x 5/8"